SilverCrest SSMP 900 A1 Mode D'emploi page 19

BB&3( 6PRRWKLH 0L[HUB%ERRN 6HLWH  )UHLWDJ  0lU]    
~ If liquid gets into the motor unit, remove
the mains plug immediately. Have the de-
vice checked before reusing.
~ Never touch the device with wet hands.
~ If the device falls into water, disconnect
the mains plug immediately. Only then
is it safe to retrieve the device.
DANGER! Risk of electric
shock
~ Only plug the mains plug into the wall
socket after the device has been com-
pletely assembled.
~ Only connect the mains plug to a prop-
erly installed and easily accessible wall
socket whose voltage corresponds to
the specifications on the rating plate.
The wall socket must continue to be eas-
ily accessible after the device is
plugged in.
~ Ensure that the power cable cannot be
damaged by sharp edges or hot points.
Do not wrap the power cable around
the device.
~ The device is not fully disconnected from
the power supply, even after it is
switched off. In order to fully disconnect
it, pull out the mains plug.
~ When using the device, ensure that the
power cable cannot be trapped or
crushed.
~ When removing the mains plug from the
wall socket, always pull the plug and
never the cable.
~ Disconnect the mains plug from the wall
socket ...
... if there is a fault,
... when you are not using the smoothie
mixer,
... during thunderstorms.
~ Do not use the device if there is visible
damage to the device or the power ca-
ble.
~ To avoid any risk, do not make modifi-
cations to the device.
DANGER! Risk of injury
from cutting
~ The blades of the blade assembly carry
on rotating after the device has been
switched off. Wait until the blades have
come to a standstill before you remove
the blender jug.
~ The blades of the blade assembly are
sharp. Please be very careful when
handling them. When washing manual-
ly, the water should be sufficiently clear
that you can see the blades easily.
~ Under no circumstances should the de-
vice be operated without the blender jug.
WARNING! Risk of material
damage
~ Do not use the blade assembly with a
flat blade for liquids!
~ Thick or firm peels, (e.g. of citrus fruits,
pineapple), stems and pips of stone
fruits (e.g. cherries, peaches, apricots)
must be removed before blending.
~ Do not put any ingredients with a tem-
perature in excess of 85 °C into the
blender jug.
~ In order to prevent damage to the de-
vice, interrupt the blending process im-
mediately if the blades of the blade
assembly rotate with difficulty or not at
all. Pull out the mains plug and investi-
gate whether there is an obstruction in
the blender jug or whether the contents
are too viscous. Also check whether the
device is assembled correctly.
~ Do not operate the device with empty
blender jugs, as this causes the motor to
overheat and may result in it being
damaged.
~ Only operate the device when a blade as-
sembly is screwed onto the blender jug.
~ The device is designed for a maximum
operating time of 60 seconds without in-
terruption. After this, the device must re-
main switched off until it has cooled
down to room temperature.
17
GB