Troubleshooting - Atag KD72102CN Notice D'utilisation

24

TROUBLESHOOTING

WARNING! Refer to Safety
chapters.
What to do if...
Problem
The appliance does not op‐
erate.
Audible or visual alarm is
on.
A or symbol is shown
instead of numbers on the
Temperature Display.
The compressor operates
continually.
Possible cause
The appliance is switched
off.
The mains plug is not con‐
nected to the mains sock‐
et correctly.
There is no voltage in the
mains socket.
The cabinet has been re‐
cently switched on or the
temperature is too high.
The temperature in the ap‐
pliance is too high.
The door is left open.
Temperature sensor prob‐
lem.
Temperature is set incor‐
rectly.
Many food products were
put in at the same time.
The room temperature is
too high.
Food products placed in
the appliance were too
warm.
The door is not closed cor‐
rectly.
Solution
Switch on the appliance.
Connect the mains plug to the
mains socket correctly.
Connect a different electrical
appliance to the mains socket.
Contact a qualified electrician.
Refer to "High temperature
alarm".
Contact a qualified electrician
or contact the nearest Author‐
ised Service Centre.
Close the door. Refer to "Door
open alarm"
Contact the nearest Author‐
ised Service Centre (the cool‐
ing system will continue to
keep food products cold, but
temperature adjustment will
not be possible).
Refer to "Operation".
Wait few hours and then
check the temperature again.
Refer to climate class chart on
the rating plate.
Allow food products to cool to
room temperature before stor‐
ing.
Refer to "Closing the door".