To Light
cont
Hold match as shown.
Turn valve to LIGHT
position and hold for 8-10
seconds.
Heater will ignite with a
brief visible flame.
Continue to hold VALVE at
LIGHT position for an
additional 10 seconds.
Release knob. It will return
to ON position. Heater is
NOT adjustable.
NOTE: Heater is
designed to be lit with the
valve fully open until it
reaches full output.
Observe heat build up for a
few minutes to ensure
heater is lit. If heater fails
to develop substantial heat,
turn heater "OFF" and
repeat lighting procedure.
To Turn Off
Turn FUEL VALVE to
OFF.
Allow HEATER to cool
for 10-15 minutes.
To Store
DANGER
• EXPLOSION - FIRE HAZARD
•
Never store propane near high heat, open flames, pilot lights, direct sunlight,
other ignition sources or where temperatures exceed 120 degrees F (49°C).
7