Connecting The Wire Ends To The Bpt-M Touch - Bosch BPT-M Touch Manuel D'installation

36 | Electrical installation
BPT-M Touch | Installation manual
5.4.2 Connecting the wire ends to the BPT-M
Touch
▶
Procedure
1. Fit a cable end sleeve to the end of the wire.
2. Use a slotted screwdriver to open the contact
spring of the connecting plug.
5.6: Connector plug pin assignment: Energy meter
Pin Assignment
(2)
S0 In +
(4)
S0 In –
3. Insert the wire end into the terminal according to
the pin assignment.
4. Check that the wire is held firmly in place.
5. Repeat steps 1 to 4 for the ends of the remaining
wires.
6. Route the unconnected wires in such a way that
they do not hang loose at the side and possibly
cause short circuits.
7. Connect the plug connector with the BPT-M Touch.
English
(4) (2)
Bosch Power Tec GmbH