Application Instructions; Shredding Attachment - Bosch ProPower MFW4 Série Mode D'emploi

■ Put the completely assembled fruit
press attachment, inclined slightly to the
right, on the drive.
■ Turn fruit press attachment upwards
until it engages.
■ Tighten threaded ring on the fruit press
attachment.
■ Attach filling tray.
■ Place suitable container under the juice
outlet opening.
■ Place bowl or plate under the opening of
the pulp nozzle.
■ Insert the mains plug.
■ Place the food to be processed in the
filling tray.
■ Switch appliance on with the On/Off
button.
■ Press food down using the pusher. Do
not exert too much pressure! Filter insert
may be damaged.

Application instructions:

■ First loosen the pulp nozzle until the
pulp (solid constituents) is still moist
when it flows out.
■ Then slowly close the pulp nozzle until
juice and pulp come out in the required
form.
After using the appliance:
■ Switch appliance off with the On/Off
button.
■ Remove mains plug.
■ Pull out the pusher.
■ Remove filling tray.
■ Remove the fruit press attachment.
Holding down the release button, turn
the attachment to the right and remove.
■ Disassemble fruit press attachment.
Disassembly is in reverse order.
■ Clean all parts, see "Cleaning and
servicing".

Shredding attachment

(some models)
For shredding and slicing cheese, fruit,
vegetables, nuts, almonds, dried bread rolls
and pieces of bread, chocolate and other
hard foods.
Operating the appliance
W Risk of injury
– Before fitting/removing attachment, wait
until the drive has come to a standstill
and pull out the mains plug.
– Do not grip the sharp blades and edges
of the shredding and slicing inserts.
– Do not reach into the feed tube. Always
use the stuffer to push food down the
hole.
X Fig. H
■ Place required insert in the housing of
the shredding attachment. The insert is
automatically locked when the appliance
is switched on.
■ Put the shredding attachment, inclined
slightly to the right, on the drive.
■ Turn shredding attachment upwards
until it engages.
■ Place a bowl or plate under the outlet
opening.
■ Insert the mains plug.
■ Place the food to be processed in the
feed tube.
■ Insert pusher and hold in place.
Note:
Pusher can be inserted in one direction
only. Note position of the curve!
■ Switch appliance on with the On/Off
button.
■ Press food down using the pusher.
Do not exert too much pressure!
After using the appliance:
■ Switch appliance off with the On/Off
button.
■ Remove mains plug.
■ Pull out the pusher.
■ Remove the shredding attachment.
Holding down the release button, turn
the attachment to the right and remove.
■ Disassemble shredding attachment.
■ Clean all parts, see "Cleaning and
servicing".
en
17