Metric/ Imperial Setting; Error Codes; Transport And Storage; Additional Information - Tunturi T20 Manuel De L'utilisateur

English

Error codes

If the display shows an error code
(marked with "E" + number), restart the equipment and check
whether the display still shows the error code. If the display still shows
the error code, immediately contact the dealer.
‼ NOTE
• E7 is not an error code, see "Safety key"

Metric/ Imperial setting

When displayed speed is not matching your expectation the machine
might be set in incorrect setting.
Metric: Min./ Max. speed/:
1.0 Km/h/ 16.0 Km/h.
Imperial: Min./ Max. speed/:
0.6 Mls/h/ 10.0 Mls/h.
Switch units by:
Take off safety key. ( Console show E7)
Press and hold "Prog" & "Mode" button for 3 seconds.
Console shows shortly:
- 0.6 When switched to Imperial mode.
- 1.0 When switched to Metric mode.
Put Safety key back in position.

Transport and storage

⚠ WARNING
• Before cleaning and maintenance, remove the mains plug from
the wall socket.
• Carry and move the equipment with at least two persons.
• Make sure that there are no other persons or objects under the
equipment.
• When folding the folding the equipment, make sure that you
hear the equipment lock into position to prevent the equipment
from dropping back down.
⚠ CAUTION
• Before folding the equipment, make sure that the incline is 0%.
If the incline is not 0%, folding will damage the mechanism.
- Move the equipment as shown (fig. F3). Move the equipment
and carefully put the equipment down. Place the equipment on
a protective base to prevent damage to the floor surface. Move
the equipment carefully over uneven surfaces. Do not move the
equipment upstairs using the wheels, but carry the equipment by
the handlebars.
- Store the equipment in the upright position (fig. F1). Store the
equipment in a dry place with as little temperature variation as
possible.

Additional information

Packaging disposal
Government guidelines ask that we reduce the amount of waste
material disposed of in land fill sites. We therefore ask that you
dispose of all packaging waste responsibly at public recycling centres.
End of life disposal
We at Tunturi hope you enjoy many years of enjoyable use from your
fitness trainer. However, a time will come when your fitness trainer will
come to the end of its useful life. Under 'European WEEE Legislation
you are responsible for the appropriate disposal of your fitness trainer
to a recognised public collection facility.

Technical data

Parameter Unit of measurement
Mains voltage VAC
Mains frequency HZ
Motor HP
Speed Km/H
Speed Mph
Incline Step
Length (folded) Cm
Length (folded) Inch
Width Cm
Width Inch
Height (folded) Cm
Height (folded) Inch
Weight Kg
Weight Lbs
Max. user weight Kb
Max. user weight Lbs
HR. receiver Handgrip contact
5.3~ 5.4 Khz.
Bluetooth (BLE)
ANT+

Declaration of the manufacturer

Tunturi New Fitness BV declares that the product is in conformity with
the following standards and directives: EN 957 (HC), 89/336/EEC. The
product therefore carries the CE label.
04-2020
Tunturi New Fitness BV
Purmerweg 1
1311 XE Almere
The Netherlands

Disclaimer

© 2020 Tunturi New Fitness BV
All rights reserved.
The product and the manual are subject to change. Specifications can
be changed without further notice.
2 2
Value
210~240
50~60
1.5
3.5 Max.
1.0~16.0
0.6~10.0
0~12
155.0
(87.0)
61.0 (34.3)
74.0
29.1
137.0 (139.0)
53.9 (54.7)
62.0
136.6
120
265



