Optional Accessories; Replacement Parts - Shure BETA 57A Mode D'emploi

Masquer les pouces

Table des Matières

Les langues disponibles

STAGE MONITOR & P.A. LOUDSPEAKER PLACEMENT

For maximum rejection of unwanted sound, place the stage

monitor or P.A. system loudspeaker at a 60° angle from the

rear of the Beta 57A, not directly behind it (see Figure 1). Al-

ways check out the stage setup before a performance to en-

sure that placement of microphone and monitors is optimum.

MONITOR

180

LOUDSPEAKER(S)

120

RECOMMENDED LOUDSPEAKER LOCATIONS

FIGURE 1

SPECIFICATIONS

Type

Dynamic (moving coil)

Frequency Response

50 to 16,000 Hz (see Figure 2)

NOTE: The curve below shows on–axis response at a

distance of 2 feet from a uniform sound source. Your

response may vary, depending on microphone position.

Á Á Á Á Á Á Á Á Á Á Á Á Á Á Á

Á Á

+10

3 mm

(1/8 IN.)

Á Á Á Á Á Á Á Á Á Á Á Á Á Á Á

25 mm

(1 IN.)

Á Á

Á Á Á Á Á Á Á Á Á Á Á Á Á Á Á

Á Á

51 mm

(2 IN.)

Á Á Á Á Á Á Á Á Á Á Á Á Á Á Á

–10

0.6 m

(2 FT)

Á Á Á Á Á Á Á Á Á Á Á Á Á Á Á Á Á

Á Á

Á Á Á Á Á Á Á Á Á Á Á Á Á Á Á

100

200

TYPICAL FREQUENCY RESPONSE

FIGURE 2

Polar Pattern

Supercardioid, rotationally symmetrical about microphone

axis, uniform with frequency (see Figure 3)

250 Hz

500 Hz

1000 Hz

TYPICAL POLAR PATTERNS

FIGURE 3

P.A. SYSTEM

LOUDSPEAKER

120

Á Á

500

1,000

2,000

5,000

10,000

2500 Hz

6300 Hz

10000 Hz

Output Level (at 1,000 Hz)

Open Circuit Voltage –51 dBV/Pa* (2.8 mV)

*1 Pa = 94 dB SPL

Impedance

Rated impedance is 150 W (290 W actual) for connection to

microphone inputs rated low Z

Phasing

Positive pressure on diaphragm produces positive voltage

on pin 2 with respect to pin 3

Connector

Three-pin professional audio connector (male XLR type)

Case

Silver blue enamel–painted die cast metal with hardened,

matte-finished steel mesh grille

Adjustable Stand Adapter

Slip–in, adjustable through 180°, with standard 5/8"-27

thread

Net Weight

275 grams (9.6 oz)

Certification

Eligible to bear CE Marking. Conforms to European EMC Di-

rective 89/336/EEC. Meets applicable tests and performance

criteria in European Standard EN55103 (1996) parts 1 and 2,

for residential (E1) and light industrial (E2) environments.

FURNISHED ACCESSORIES

Adjustable Stand Adapter

5/8" to 3/8" (Euro) Thread Adapter

Storage Bag

Á Á