Lindy 38263 Guide D'installation Rapide page 4

User Manual
Overview
Front Panel
1. Power LED – Flashes during power up and stays illuminated whilst the unit is operating.
IR Eye – Receives the IR signal from the included IR remote control
2.
Rear Panel
1. IR Ext - Connects to the provided IR extender to extend the IR control range of the unit.
2. Control – Socket reserved for factory updates
3. RS-232 – Serial socket to be connected with a serial controller or PC through the supplied terminal
4. Trigger IN: Connects any trigger device (not supplied) such as, control keypads, security alarms, door switches,
etc. Each of the 8 trigger inputs can be used to activate an associated preset. The trigger needs a minimum of
5V to be activated
5. HDMI OUT port – Connects a display with a standard HDMI cable (not included) used for direct local monitoring
/ management of the unit.
Connects a USB mouse and/or keyboard to control the unit's WebGUI displayed on the HDMI output
6. USB:
port. Firmware update via USB is also supported.
Note: Specialized USB control devices, such as a touch panel, should be connected before the unit is
powered on.
7. LAN 2 – Connect this port to the network used to control the unit via WebGUI / Telnet
8. LAN 1 (PoE) – This port must be connected to the network where all the controlled units (No. 38266 and 38267
– not included) are connected to. If this port is connected to an IEEE802.3af. compliant switch the unit can get
power directly from it avoiding to use the included PSU.
9. DC Power socket – Attach the supplied PSU here.
English