Charging the helicopter
Preparation of flight
Use 8 AA 1,5V Batteries for operating the controller. Don´t use rechargeable batteries.
Place the helicopter on a plain surface, the tail rotor must point in your direction. Switch on
the helicopter. Make sure that no obstacles affect flying. Step back for at least 3 meters and
switch on the controller.
How to bind
To bind the controller with the helicopter, please follow these steps:
- Switch on the controller
- Switch on the helicopter
- Red LED on the helicopter flashes for 3-5 times
- Move gas stick up and down
This procedure must only be performed before your first flight!
zoopa
350
To charge the LiPo battery, connect the
power adaptor with the charger.
Connect the white balancer plug with the
charger port.
Charging takes, depending on the battery
condition, up to one hour. The LED flashes
green when the battery is fully charged.
Always follow the safety instructions of
this manual when charging the battery.
www.ACME-online.net