Electrical Connection - Franke FGC 915 I XS LED Mode D'emploi

Fitting the Panel and Fixing the Hood Canopy
Before fixing the Hood Canopy to the Frame:
• Remove the Grease filters from the Hood Canopy;
• Remove any Activated charcoal filters.
• Working from below, fix the Hood canopy to the Frame
provided, using the 4 screws 12f (M6 x 10) provided.
• Then hook the upper part of the Panel 3, adjusted to size, to
the rubber supports in the upper part and in the lower part
of the Frame.
• Slide the lower part of the Panel 3 until its metal tabs slot
into the slots in the frame;

ELECTRICAL CONNECTION

• Connect the hood to the mains through a two-pole switch
having a contact gap of at least 3 mm.
• Remove the grease filters (see paragraph Maintenance) be-
ing sure that the connector of the feeding cable is correctly
inserted in the socket placed on the side of the fan.
EN
12f
1
12