Yamaha Motor 40 Manuel D'installation page 160

2
1
3
4
2
a
3
4
5
5
8.0 mm (0.31 in)
151
3. Install:
• Cable stopper 1
• Shift cable 2
• Throttle cable 3
• Bolt 4
• Grommet 5
4. Adjust:
• Shift cable joint position
Adjustment steps:
• Set the shift lever 1 to the neutral posi-
tion.
• Align the center of the set pin 2 with the
mark a on the bracket.
• Adjust the position of the cable joint 3
until its hole aligns with the set pin.
• Install the clip 4, and then tighten the
locknut 5.
WARNING
The cable joint must be screwed in a
minimum of 8.0 mm (0.31 in).
5. Check:
• Shift operation
Unsmooth operation → Adjust.
Checking steps:
• Turn the throttle grip to the fully closed
position.
• Check the shift lever for smooth operation
by shifting the lever from neutral to forward
and reverse.
E