Rear Water Collection Tray Installation; Extension Table Installations; Saw Operation; Adjustable Cutting Table Extension - Brutus 61024BR Manuel D'utilisation

G. REAR WATER COLLECTION
TRAY INSTALLATION
Insert and attach the rear water collection tray to the
main water tray at the corresponding joints (FIGURE 12).
FIGURE 12
H. EXTENSION TABLE INSTALLATIONS
Front extension table: Place the extension table in the
back of the main working table. Secure the extension table
with the supplied round cap hex bolts (FIGURE 13).
Side extension table: Insert the side extension table
tubes into the side tunnels at front and back of the
main working table. Insert the pins at the ends of side
extension table tubes to hold them in place (FIGURE 13).
FIGURE 13

SAW OPERATION

WITHOUT FIRST TURNING OFF THE MOTOR. FAILURE
TO DO SO MAY RESULT IN SERIOUS INJURY TO THE
OPERATOR.
CLEAR. NEVER PUT THINGS ON RAIL WHILE
CUTTING.
DO NOT ADJUST THE SAW
ALWAYS KEEP THE SAW
ADJUSTABLE CUTTING TABLE
EXTENSION
The adjustable cutting extension table is for the support
of large format tiles. Users can adjust front and side
extension to desired dimension (Figure 14).
FIGURE 14

CUTTING TILE AND STONE

CUTS, CHECK AND ENSURE THAT THE LOWEST
POINT OF THE BLADE IS NO MORE THAN 3/16 INCH
(5 MM) BELOW THE TABLE TOP (FIGURE 15).
Blade
Surface of working table
FIGURE 15
Move the motor head height adjustment lever upward
(FIGURE 16), to adjust the head to a proper height below
the table. Then lock the lever in the down position.
FIGURE 16
– 8 –
BEFORE PERFORMING ANY
Blade
rim
3/6 in.
(5 mm)
Motor head height
adjustment lever