Mounting The Spotlight; Positioning The Spotlight; Solar Panel - LIVARNO home 1020-B Instructions D'utilisation Et Consignes De Sécurité

fixings are best suited for the surface on
which you intend to mount the light. If
necessary, you should seek the advice of an
expert.
When deciding where to mount the
light, pay attention to the following:
Ensure the product illuminates the desired
„
area. Make sure that the motion sensor
covers the desired area.
The motion sensor has a maximum
„
detection range of 10m with a field of view
of approx. 120°.
Ensure that the motion sensor
„
position where street lighting will shine on it
at night. This may impair the function.
The recommended installation height is 2 to
„
4m. If possible, mount the Spotlight in a
position where it will not be exposed to dirt
or dust and is protected from rain (e.g.
under a roof overhang) and other
weathering effects.
Please note: the solar panel
positioned where it will be exposed to as
much direct sunlight as possible. Even partial
shade during the day can significantly
impair the charging process.
Orientation:
The optimum alignment is facing south.
Choose an orientation facing slightly to the
west rather than slightly to the east.
z Mounting the Spotlight
Transfer the positions of the guide holes
„
/ to the mounting point on the wall.
13
Drill two holes (dia. 6mm) and insert the
„
matching wall plugs
G).
Mounting model 1020-B
Screw the screws
„ 7
leaving a gap of approx. 3mm between the
screw head and the wall (see Fig. C).
Slot the guide holes
„
4
is not in a
4
should be
2
3
(see Figs. C and
8
into the wall plugs
8
over the screws and
3
then slide the Spotlight along the guides to
fix it in place (see Fig. C).
If necessary, adjust the gap between the
„
screw heads and the mounting surface to
provide a firm seating for the Spotlight.
Mounting model 1020-S
Screw the wall bracket
„
by inserting the screws
guide holes
13
firmly tightening them (see Fig. G).
Fix the Spotlight to the wall bracket
„
loosening the Spotlight star knob
removing the screw
Align the holes in the Spotlight with the
„
holes in the wall bracket and slot the screw
through the holes (see Fig. F).
12
Screw the Spotlight star knob
„
screw and tighten it hand-tight. Check that
the product is fixed firmly in place.
z Positioning the Spotlight/

solar panel

Positioning model 1020-B
The Spotlight can be adjusted horizontally
(top/bottom) to an angle of up to 180° (see
Fig. D).
Loosen the two Spotlight star knobs
„
adjust the Spotlight (see Fig. B).
When the desired position is obtained,
„
tighten the star knobs again. If necessary,
use a screwdriver to hold the screw while
tightening the star knob.
Positioning model 1020-S
The Spotlight can be adjusted horizontally
(top/bottom) to an angle of up to 180° (see
Fig. H).
, Loosen the wall bracket star knob
„
adjust the height of the Spotlight (see Fig.
H).
When the desired position is obtained,
„
firmly in place
11
through the
7
into the wall plugs
8
11
and
9
�
12
onto the
6
6
10
GB/IE/NI/CY/MT
and
by
to
to
49