Inflating Instructions - Pigro Felice MODUL'AIR Mode D'emploi

BUILDING YOUR MODUL'AIR
LA CONSTRUCCIÓN DE SU MODUL'AIR
ASSEMBLER VOTRE MODUL'AIR
Long Straps
are used when parts
are stacked on top each other.
Los Clips Largos
se utilizan
cuando las piezas se apilan una
encima de las otras.
Clips longs
pour assembler des
unités les unes sur les autres.
ARMCHAIR
4 Long Straps
SOFA
6 Long Straps
2 Short Straps
6
Short Straps
are used when parts are placed
next to each other.
Los Clips Cortas
se utilizan cuando se colocan
las piezas una a lado la otra.
Clips courts
pour assembler des unités les
unes à côté des autres.
LOUNGER
2 Long Straps
1 Short Strap
DOUBLE LOUNGER
2 Long Straps
4 Short Straps
WARNING
• Do not use this product in over-chlorinated water, excess of chlorine might lead to color
fading, which is not be covered by the warranty. NOTE: This product should not be placed in
a pool where chlorine is being added; the chlorine level might be too high. This product
should not be used before the chlorine maintenance procedure. Wait at least ONE DAY before
using this product after the chlorine maintenance procedure has been done.
WHEN USING THIS PRODUCT:
• Remember that it is for swimmers ONLY. This product is not a toy or a lifesaving device.
• Do not allow jumping and walking onto, or off, the product.
• Do not use in high wind, open water or in dangerous tides.
• Do not use sharp objects while sitting on the product - this could lead to damage.
• Do not exceed the maximum recommended weight capacity of each product.
• Do not use the product if there is leakage or a puncture.
• Do not use for extreme water sport activities.
• Do not use in wreckage areas; this product should only be used on flat surfaces.
• Do not swim underneath the device.
• Use only under competent supervision.
• Keep it away from children who are under the age of 14. MUST BE 14 YEARS OF AGE TO USE.
• Remember that it is made of synthetic material that can melt when exposed to heat or fire.
Do not place the product near heating elements, open fire, or other hot objects.
• Do NOT use the pump if the electricity cable is damaged.
• Dry your hands while using the pump to inflate the product. Do NOT use the pump near
water.
• Remember that the pump should be used in a clean area, away from sand, water, and grass.
When inflating, the unused opening of the pump will suck in air, which will damage the
pump; therefore; it is imperative that the pump does not suck in sand, or any other dirt.
• Do NOT exceed the inflation pressure of: 0.07 bar.
• Do NOT attempt to disassemble, repair, or service the pump or the device. The end user
cannot maintain the parts of the pump.

INFLATING INSTRUCTIONS

1. Locate a clean flat area that is free of stones and other sharp objects.
2. After inflating, make sure that the device is firm when touched, but not too hard.
CAUTION: To prevent bursting, do not over-inflate or use a high-pressure air compressor;
do not exceed the recommended design working pressure. Fill with cold air only.
3. Close and recess the inflation valve securely.
ENGLISH
7