Assembly - Ryobi RY803000E Manuel D'utilisation

UNPACKING
This product requires assembly.
 Carefully remove the product and any accessories from
the box. Make sure that all items listed in the packing list
are included.
NOTE: This tool is heavy. To avoid back injury, lift with
your legs, not your back, and get help when needed.
WARNING:
Do not use this product if any parts on the Packing List
are already assembled to your product when you unpack
it. Parts on this list are not assembled to the product by
the manufacturer and require customer installation. Use
of a product that may have been improperly assembled
could result in serious personal injury.
 Inspect the tool carefully to make sure no breakage or
damage occurred during shipping.
 Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the tool.
 If any parts are damaged or missing, please call
1-800-860-4050 for assistance.
PACKING LIST
Pressure Washer
25 ft. High Pressure Hose
Trigger Handle
Spray Wand
Quick-Connect Nozzles (4)
4-Cycle Engine Lubricant (SAE 30 or SAE 10W30)
Disposable Funnel
Handle
Operator's Manual
WARNING:
If any parts are damaged or missing do not operate this
tool until the parts are replaced. Use of this product
with damaged or missing parts could result in serious
personal injury.
WARNING:
Do not attempt to modify this tool or create accesso-
ries not recommended for use with this tool. Any such
alteration or modification is misuse and could result in a
hazardous condition leading to possible serious personal
injury.

ASSEMBLY

WARNING:
To prevent accidental starting that could cause serious
personal injury, always disconnect the engine spark plug
wire from the spark plug when assembling parts.
INSTALLING THE HANDLE
See Figure 2.
CAUTION:
Be careful to avoid pinching your fingers or hands when
installing the handle onto the frame.
 Push and hold the buttons on the frame as you slide the
handle over the lock buttons on the frame.
NOTE: Before use, pull the handle up until the lock button
snaps through the locking slot to secure the handle in
place.
CONNECTING THE SPRAY WAND TO THE
TRIGGER HANDLE
See Figure 3.
 Place the threaded end of the spray wand in the connec-
tor on the end of the trigger handle.
 Turn the connector until it stops to secure the spray wand
in place.
CONNECTING THE BATTERY
See Figure 4.
WARNING:
To reduce the risk of electric shock or explosion, do not
short circuit the battery terminals or charge in a sealed
container. Keep sparks and flame away. Do not use metal
tools for connections and keep metal objects away from
the battery terminals. Metal objects can make a connec-
tion from one terminal to another. Shorting the battery
terminals together can cause sparks, burns, or a fire.
The starter cable on the pressure washer must be connected
to the connection port on the battery and the battery must be
fully charged before the electric start feature of the pressure
washer can be operated.
To connect the battery:
 Remove the cap from the connection port on the battery.
 Connect the starter cable on the pressure washer to the
connection port on the battery, making sure the plug is
fully seated.
Page 7 — English