Triton RTA300 Instructions D'utilisation Et Consignes De Sécurité page 4

e) Maintain power tools. Check for misalignment or
binding of moving parts, breakage of parts and
any other condition that may affect the power
tool's operation. If damaged, have the power tool
repaired before use. Many accidents are caused by
poorly maintained power tools.
f) Keep cutting tools sharp and clean. Properly
maintained cutting tools with sharp cutting edges are
less likely to bind and are easier to control.
g) Use the power tool, accessories and tool bits etc.
in accordance with these instructions, taking into
account the working conditions and the work to
be performed. Use of the power tool for operations
different from those intended could result in a
hazardous situation.
5) Service
a) Have your power tool serviced by a qualified repair
person using only identical replacement parts.
This will ensure that the safety of the power tool is
maintained.
Safe use of the router table
Always follow these safety instructions when using
your router table
• Always feed the workpiece against the direction of
rotation arrows (printed around the central hole)
• Always feed from the front panel (switchbox end) of the
Workcentre or Router Stand, with the workpiece to the
left of the cutter
• Never trail your fingers behind the workpiece. Always
use the fence if using a cutter without a bearing or pilot
• For free-hand work use only bearing or pilot guided
cutters
• Use the safety guard whenever possible, and keep it
correctly adjusted
GB
Safety Instructions
4
• Always disconnect your router from power whenever
changing or adjusting cutters
• Always check that the cutter is clear of the MDF
fence faces, the insert ring, the safety guard and the
workpiece before starting the router
• Remove all loose objects from the table before
operating to prevent them from vibrating into the cutter.
• Always disconnect power when work is completed for
the day, or when leaving the unit unattended
• Follow all safety instructions supplied with your router
Wear goggles
Wear ear defenders
Wear a respiratory mask
Wear protective clothing
Wear gloves
The tool must be used only for its prescribed purpose.
Any use other than those mentioned in this manual will
be considered a case of misuse. The user and not the
manufacturer shall be liable for any damage or injury
resulting from such cases of misuse.
The manufacturer shall not be liable for any
modifications made to the tool nor for any damage
resulting from such modifications.
Even when the tool is used as prescribed it is not
possible to eliminate all residual risk factors. The
following hazards may arise in connection with the
tool's construction and design:
• Damage to eyes if effective protections is not worn
• Damage to the lungs if an effective dust mask is not
worn
• Damage to hearing if effective ear protection is not
worn