Introduction; Scope Of Delivery - Kity KS216S Traduction Des Instructions D'origine

1. Introduction

MANUFACTURER:
scheppach
Fabrikation von Holzbearbeitungsmaschine GmbH
Günzburger Straße 69
D-89335 Ichenhausen
DEAR CUSTOMER,
We hope your new tool brings you much enjoyment
and success.
NOTE:
According to the applicable product liability laws, the
manufacturer of the device does not assume liability
for damages to the product or damages caused by
the product that occurs due to:
• Improper handling,
• Non-compliance of the operating instructions,
• Repairs by third parties, not by authorized service
technicians,
• Installation and replacement of non-original spare
parts,
• Application other than specified,
• A breakdown of the electrical system that occurs
due to the non-compliance of the electric regu-
lations and VDE regulations 0100, DIN 57113 /
VDE0113.
WE RECOMMEND:
Read through the complete text in the operating in-
structions before installing and commissioning the
device. The operating instructions are intended to
help the user to become familiar with the machine
and take advantage of its application possibilities in
accordance with the recommendations. The operat-
ing instructions contain important information on how
to operate the machine safely, professionally and
economically, how to avoid danger, costly repairs, re-
duce downtimes and how to increase reliability and
service life of the machine.
In addition to the safety regulations in the operating
instructions, you have to meet the applicable regula-
tions that apply for the operation of the machine in
your country. Keep the operating instructions pack-
age with the machine at all times and store it in a
plastic cover to protect it from dirt and moisture. Read
the instruction manual each time before operating the
machine and carefully follow its information. The ma-
chine can only be operated by persons who were in-
structed concerning the operation of the machine and
who are informed about the associated dangers. The
minimum age requirement must be complied with.
2. Layout (Fig. 1 - 20)
1. Handle
2. On/off switch
3. Unlocking lever
4. Machine head
5. Moving saw blade guard
6. Saw blade
7. LED
8. Laser
9. Set screw for rotary table
10. Stop rail
10a.Moveable stop rail
11. Right workpiece support
11a.Left workpiece support
11b.Philips screw for workpiece support
12. Set screw for workpiece support
13. Set screw for table insert extension
14. Table insert extension
15. Pointer
16. Scale
17. Rotary table
18. fixed saw table
19. Clamping device
20. Set screw for cable routing
20a.Cable routing
21. Dust bag
22. Clamping grip
23. Adjusting screw (45°)
24. Adjusting screw (90°)
25. Bracket for table insert extension
26. Pointer
27. Scale
28. Laser & LED on/off switch
29. Stop for cutting depth limiting
30. Screw for cutting depth limiting
31. Pin
32. Locking pin
33. Sawing shaft lock
34. Flange screw
a.) Lock nut
b.) 90° stop bracket (not included in the scope of sup-
ply)
c.) 45° stop bracket (not included in the scope of sup-
ply)
d.) Allen key size 6
e.) Philips screw
f.) Wrench size 13
g.) Philips screw (laser)

3. Scope of delivery

• Open the packaging and remove the device care-
fully.
• Remove the packaging material as well as the
packaging and transport bracing (if available).
• Check that the delivery is complete.
• Check the device and accessory parts for trans-
port damage.
GB 19