Singercon CON.FM-1500 12L Manuel D'utilisation page 6

EN
e) To prevent the device from accidentally switching on,
make sure the switch is on the OFF position before
connecting to a power source.
f) The device is not a toy. Children must be supervised
to ensure that they do not play with the device.
g) Danger! Generated smoke and smoke outlet (nozzle)
are very hot. Be careful when using the device.
h) Do not lean against the appliance. Do not store
anything on the appliance.
2.4. SAFE DEVICE USE
a) Do not overload the device. Use the appropriate tools
for the given task. A correctly-selected device will
perform the task for which it was designed better and
in a safer manner.
b) Do not use the device if the ON/OFF switch does not
function properly (does not switch the device on and
off). Devices which cannot be switched on and off
using the ON/OFF switch are hazardous, should not
be operated and must be repaired.
c) Disconnect the device from the power supply
before commencement of adjustment, cleaning and
maintenance. Such a preventive measure reduces the
risk of accidental activation.
d) When not in use, store in a safe place, away from
children and people not familiar with the device who
have not read the user manual. The device may pose
a hazard in the hands of inexperienced users.
e) Keep the device in perfect technical condition. Before
each use check for general damage and especially
check for cracked parts or elements and for any other
conditions which may impact the safe operation of
the device. If damage is discovered, hand over the
device for repair before use.
f) Keep the device out of the reach of children.
g) Device repair or maintenance should be carried out by
qualified persons, only using original spare parts. This
will ensure safe use.
h) To ensure the operational integrity of the device, do
not remove factory-fitted guards and do not loosen
any screws.
i) When transporting and handling the device between
the warehouse and the destination, observe the
occupational health and safety principles for manual
transport operations which apply in the country
where the device will be used.
j) Do not touch articulated parts or accessories unless
the device has been disconnected from the power
source.
k) Do not move, adjust or rotate the device in the course
of work.
l) Do not leave this appliance unattended while it is in
use.
m) Clean the device regularly to prevent stubborn grime
from accumulating.
n) Do not cover the air intake and outlet.
o) The device is not a toy. Cleaning and maintenance may
not be carried out by children without supervision by
an adult person.
p) Do not run the device when empty.
q) It is forbidden to interfere with the structure of
the device in order to change its parameters or
construction.
r) Keep the device away from sources of fire and heat.
s) Keep the device in a horizontal position. Do not tilt or
rotate the device.
10
t) Do not operate the device without appropriate liquid.
u) Do not add flammable and hazardous liquids, gas or
perfume to the liquid tank.
v) Protect the device from extreme temperatures, dust,
water and moisture, strong vibrations and mechanical
forces during use
w) Do not use or place naked flames, lighters, matches,
etc. near the device when it is operated.
x) Do not operate the device near transformers or
highpower motors.
y) When operating the device, follow all the laws in force
in the country concerned.
z) Do not tilt the device liquid may leak inside the device
causing damage or hazard for the user.
ATTENTION! Despite the safe design of the device
and its protection facilities and despite the use of
additional elements protecting the operator, there is
still a slight risk of an accident or injury when using
the device. When using the device stay alert and use
common sense.
3. USE GUIDELINES
The device is intended for generating smoke/fog effects by
heating special liquids.
The user is liable for any damage resulting from
unintended use of the device.
3.1. DEVICE DESCRIPTION
DEVICES AND BACK PANELS
ATTENTION! This product's view can be found on the
last pages of the operating instructions (pp.39-42).
Number Elements Description
1 Smoke outlet
(nozzle)
2 Liquid tank
3 LEDs
4 Back panel
5 Display
6 Power inlet
7 Fuse
8 Wireless remote
control receiver
input
9 Wired remote
control input
10 DMX OUT
11 DMX IN
12 DMX512 input
13 Shows the amount
of fluid in the
Liquid level viewer reservoir:
EMPTY- empty
FULL- full
14 Informs about the
Control LED - red
heating process
15 Indicates that the
Control LED - green
fog device is ready
16 ON/OFF Switch
17 "S" button Pump control
18 LED light switch /
MENU (M) button
LED mode selection
19 "˄" button LED color change
20 "˅" button LED color change
21 Starting the fog
ENTER button
production
22 "+" button LED color change
23 "-" button LED color change
24 Starting the fog
"A" / " " buton
production
25
"B" / " " buton Fogging switch
3.2. PREPARING FOR USE
APPLIANCE LOCATION
The temperature of environment must not be higher than
40°C and the relative humidity should be less than 85%.
Ensure good ventilation in the room in which the device
is being used. There should be at least 30 cm distance
between each side of the device and the wall or other
objects. The device should always be used when positioned
on an even, stable, clean, fireproof and dry surface, and
be out of the reach of children and persons with limited
mental and sensory functions. Position the device such that
you always have access to the power plug. The power cord
connected to the appliance must be properly grounded
and correspond to the technical details on the product
label.
3.3. DEVICE USE
3.3.1. OPERATION
1. Connect the power cable to an earthed power supply.
2. Connect the plug (if equipped) to the device:
controller/receiver for wireless remote control/ wired
remote controller.
3. Set the ON / OFF switch to the „ON" position.
4. Control the device via the control panel, remote
controls or DMX controllers.
5. Spray the smoke when the device is fully warmed.
6. To turn off the device, turn the ON / OFF switch to the
„OFF" position, then disconnect the device from the
power source.
EN
3.3.2. DMX CONTROL AND CHANNELS
1) The ability to control the device depending on the
model (+ yes, - no):
CON.FM-1500 12L + + - +
CON.FM-1200 - + - +
CON.FM-900B - + - -
CON.FM-900A - + - -
CON.FM-900 - + + -
CON.FM-500 - + + -
CON.FM-400 4L - + + -
2) Description of the controls
A) Built-in control panel (CON.FM-1500 12L model only)
- located on the rear panel, it allows you to control
directly on the device. Using the buttons, you can
turn on the LED lights, change their color and start
producing fog.
B) Wireless remote control - allows you to turn on the
LED lights, change their color and turn on and off
the generation of fog (functions depending on the
model, description of point 3.1.) From a distance of up
to 20 m from the device. Requires a special receiver,
included in the set, to be connected to the rear panel
of the device (only the CON.FM-1500 12L model has
a built-in receiver).
C) Wired remote control - connected to the rear panel,
it allows you to control the device from a distance. It
allows you to start and stop the generation of fog.
Thanks to the LEDs, it also informs whether the device
is warming up or is in standby mode.
D) DMX controller - on the rear panel of the device there
are inputs for connecting universal DMX controllers
(not included in the set).
3) DMX channels
Model CON.FM-1500 12L
Channel Function
CH1 Fog production (no colors)
CH2 Automatic multicolor
CH3 Light – red
CH4 Light – green
CH5 Light – blue
CH6 LED strobe
CH3+CH6 Light – red + LED strobe
CH4+CH6 Light – green + LED strobe
11