Troubleshooting; Security Advices; Disposal Of The Old Device - CASO DESIGN Crema Mode D'emploi

THE JUG: Clean immediately after each use. Flush and clean the inner walls with using
warm soapy water and a non-abrasive cloth. Then wipe dry with a soft cloth.
► For better cleaning you can fill water with a splash of rinsing agent until the min-marking
and use the device with the function for warm milkfroth. After that clean the jug with clear
water and dry it.
THE LID: Separate the lid with the silicon ring from the jug. Wash it out with water directly.
THE WHISKS: Remove from the jug and wash with warm water. Dry and store in a safe
place. Do not use the dishwasher.
Jug, lid, whisks and the basis with cable are not suitable for dish washer.

21 Troubleshooting

This chapter provides you with important notices with regard to operating the device.
Observe the following notices to avoid dangers and damages:

21.1 Security advices

ATTENTION
► Repairs of electrical appliances must be carried out by qualified personnel who are
trained by the manufacturer.
► Repairs performed by untrained persons may result in considerable hazards for the user
and damage the machine.
21.2 Troubleshooting
Error Possible cause
Mains plug is not connected
The appliance
correctly.
doesn't work.
Electronic defect.
ATTENTION
► If above mentioned steps don't solve the problem, please contact your customer
service.

22 Disposal of the Old Device

Old electric and electronic devices frequently still contain valuable materials.
However, they also contain damaging substances, which were necessary for their
functionality and safety.
If these were put in the non-recyclable waste or were handled incorrectly, they
could be detrimental to human health and the environment. Therefore, do not put
Caso Fomini Crema & Fomini Crema Inox
Please note
Problem solving
Please check that the mains plug of the
applicance is connected correctly.
Please contact customer support.
35