Astralpool 52143 Manuel D'installation Et D'entretien page 3

• In this regard:
o IEC 364-7-702 standards must be observed: WIRING IN BUILDINGS SPECIAL WIRING SWIMMING POOLS
o IEC 364-7-714: ELECTRICAL INSTALLATIONS IN BUILDINGS. OUTDOOR LIGHTING INSTALLATIONS.
• All maintenance operations should be performed with the projector disconnected from the Mains.
6. ASSEMBLY AND FUNCTIONING WARNINGS:
• It is not recommended the use of sealing putty in this product and, anyway, you should use only products specifically
conceived to work with ABS, all those products of universal use remain excluded.
• The projector is designed TO OPERATE ONLY WITH A SAFETY TRANSFORMER.
• The manufacturer is not responsible in any circumstances for assembly, installation or start-up of any electric
components which have been inserted or handled at locations other than its own premises.
• It is responsibility of the installer to ensure that no water gets inside the projector by means of the cables.
• This projector is not designed to work submerged in seawater.
• This projector is resistant to pool treatments described below, always that the concentration values do not exceed the
following levels:
Attention : Please note that the Ph of pool water always must be between 7.2 and 7.6.
TYPE OF TREATMENT
Chlorine
Bromine
Salt electrolysis (Na Cl)
CONCENTRATION IN WATER
2 g/l
5 g/l
6 g/l
3