Anleitung BSF 55_SPK7:_
13. Troubleshooting guide
Warning: Switch off the engine and pull out the ignition cable before making any checks or adjustments.
Warning: If, after making an adjustment or repair to the engine, you let it run for a few minutes, remember that
the exhaust and other parts will get hot. Do not touch these parts as these may burn you.
Fault
The unit does not operate
smoothly and vibrates intensively
Engine does not run
Engine does not run smoothly
Drive power falls
The engine will not start or dies
after a short period of time
Inadequate or no ejection
The snow is not removed fully
14.01.2008
8:59 Uhr
Seite 19
Possible causes
- Bolts loose
- Plow unit mounting loose
- Throttle lever in wrong position
- Spark plug defective
- Fuel tank empty
- Petrol cock closed
- Air filter dirty
- Spark plug dirty
- Clutch play too large
- Automatic oil cut-out tripped
- Spark plug sooted
- No fuel
- Snow ejection unit blocked
- Plow screw not turning
- Shearing bolts (Fig. 21 / Item 30)
sheared
- Skids maladjusted
GB
Remedy
- Check bolts
- Check plow unit mounting
- Check setting
- Replace spark plug
- Top up fuel
- Open petrol cock
- Clean the air filter
- Clean the spark plug
- Adjust clutch cable
- Contact authorized customer
service
- Check oil level, top up engine oil
- Clean or replace spark plug
(electrode spacing 0.6 mm)
- Top up fue
- Clean the snow ejection unit with
a solid object
- Adjust clutch cable.
- Replace shear bolts or contact
authorized customer service
- Adjust the skids (Fig. 22 / Item
10)
19