For Best Results - Faber BELA30SS600-B Instructions D'installation

For Best Results

Start the rangehood several minutes before cooking to develop proper airflow. A llow the rangehood to
operate for several minutes after cooking is complete to clear all smoke and odors from the kitchen.
A B
Button Function
A Turns the suction motor on and off at speed one.
B Decreases the working speed.
C Increases the working speed.
D Activate intensive speed from any other speed,
including motor off. This speed is set to operate for
6 minutes, after which the system returns to the
speed that was set before. Suitable to deal with
maximum levels of cooking fumes.
Press and hold the button for approximately 5
seconds, with all the loads turned off (Motor and
Lights), to turn the Activated Charcoal Filter alarm
On and Off.
24H function
Turns the suction motor on at speed one and effects
one 10 minute extraction every hour.
When the filters alarm is triggered, the alarm can
be reset by pressing and holding this button for
approximately 3 seconds.
These indications are only visible when the motor
E
is turned off.
F Delay function
Activate automatic switch-off with a 30' delay.
Suitable to complete elimination of residual odours.
Can be activated from any position, and is disabled
by pressing the button or turning the motor off.
Press and hold the button for approximately 5
seconds, with all the loads turned off (Motor and
Lights), to turn the Remote Control On and Off.
Turns the lighting system on and off at maximum
G
intensity.
Turns the Courtesy Lighting on and off.
H
USE AND CARE INFORMATION
C D E F
Display
Displays the set speed
Displays the set speed
Displays the set speed
Displays HI and the time remaining once very
second.
FC+Punto (2 flashes)–Alarm On.
FC+Punto (1 flash)–Alarm Off.
Displays 24 and the spot at the bottom right flashes
once every second, while the motor is running.
It is disabled by pressing the button.
FF flashes three times.
When the procedure terminates, the indication
shown previously turns off:
FG indicates the need to wash the metal
grease filters. The alarm is triggered after the Hood
has been in operation for 100 working hours.
FC indicates the need to change the
activated charcoal filters, and also to wash the
metal grease filters. The alarm is triggered after the
Hood has been in operation for 200 working hours.
Displays the operating speed and the spot at the
bottom right flashes once a second.
IR+Punto (2 flashes)– Remote Control On.
IR+Punto (1 flash)– Remote Control Off.
G H
14