Dolmar TM-102.16 Manuel D'utilisation page 109

UNPACKING AND ASSEMBLY
device in the electronics card from cutting in, never start the engine until the battery
is fully charged!
WARNING!
!
safe handling and disposal.
3.5 GRASS-CATCHER SUPPORT ASSEM-
BLY
Fit the two brackets (1) on the rear plate (2),
using for each bracket three screws (3)
which are supplied, as shown, without fully
tightening the nuts (4).
Attach the grass-catcher to the brackets and
centre it with the rear plate (2). Adjust the
position of the two brackets (1) to the stop
(5) so that, when turning the grass-catcher
frame, the pin (6) slots into the seat (7) cor-
rectly.
Having checked that the grass-catcher
rotates as above, tighten the fixing nuts (4)
securely.
3.6 ASSEMBLING THE LEVERS FOR TIP
PING THE GRASS-CATCHER (
electric lifting models)
Position the lever axle (1) in the notch of the
two plates (2) and attach them on the inter-
nal side of the grass-catcher supports (3),
using the included screws (4) in the
sequence shown.
Connect the end of the rod (5) of the lifting
piston to the lever (6) with the pin (7) and
attach the two snap rings (8).
Follow the battery manufacturer's instructions regarding
➤
1
3
5
1
4 3
In
8 (x 2)
1
7
6
4 1 4
2 8
6
11
EN
4
2
3 4
7 5
8