Spare Parts And Accessories; Disposal Information; Conformity; Exemption From Liability - Flex RSP DW 18.0-EC Notice D'instruction D'origine

RSP DW 18.0-EC
Gear
NOTE
Do not loosen the screws on the gear head
during the warranty period. Failure to comply
with this requirement will invalidate any claims
under the manufacturer's warranty.
Repairs
Repairs may be carried out by an authorised
customer service centre only.

Spare parts and accessories

For other accessories, in particular cutting
accessories, please refer to
the manufacturer's catalogues.
Exploded drawings and spare-part lists can
be found on our homepage:
www.flex-tools.com

Disposal information

WARNING!
Render redundant power tools unusable:
mains operated power tool by removing
–
the power cord,
battery operated power tool by removing
–
the battery.
EU countries only
Do not throw electric power tools
into the household waste!
In accordance with the European Directive
2012/19/EU on Waste Electrical and
Electronic Equipment and transposition into
national law used electric power tools must
be collected separately and recycled in an
environmentally friendly manner.
Raw material recovery instead of
waste disposal.
Device, accessories and packaging should be
recycled in an environmentally friendly
manner. Plastic parts are identified for
recycling according to material type.
WARNING!
Do not throw batteries into the household
waste, fire or water. Do not open used
batteries.
EU countries only:
In accordance with Directive 2006/66/EC
defective or used batteries must be recycled.
NOTE
Please ask your dealer about disposal
options.

conformity

We declare on our sole responsibility that the
product described under "Technical data"
conforms to the following standards or
normative documents:
EN 62841 according to the provisions of
Directives 2014/30/EU, 2006/42/EC,
2011/65/EU.
Responsible for technical documents:
FLEX-Elektrowerkzeuge GmbH, R & D
Bahnhofstrasse 15, D-71711 Steinheim/Murr
20.04.2018
FLEX-Elektrowerkzeuge GmbH
Bahnhofstrasse 15, D-71711 Steinheim/Murr

Exemption from liability

The manufacturer and his representative are
not liable for any damage and lost profits due
to interruption in business caused by the
product or by an unusable product.
The manufacturer and his representative are
not liable for any damage which was caused
by improper use of the power tool or by use of
the power tool with products from other
manufacturers.
23