Storch ProCut top Mode D'emploi page 53

Device description / ProCut top rear view
24
Device description - Setup /
initial operation of ProCut top:
The device is transported and delivered in a plastic case:
Open the case and remove the device.
Do not use the cutting bow (17) to remove the device from
17 2
20 a 11
20 a
21
22
23
20 b
25
11
10
25 10 20 b
53
10 Freestanding support
11 Stand
20 a Rubber foot
20 b Rubber foot
21 Corner cutter socket
22 Transformer
23 Locking screw for bearing rail, left
24 Cross bar
25 Locking bolt for freestanding support
the case. Grasp the device by the transport
handle (no. 2) in the wooden panel and remove
it from the case.
Position the device in the same way as it is re-
moved from the case; i.e. on its rubber feet (20 a+ b) lo-
cated on the long side.
2 Transport handle
10 Freestanding support
11 Stand
17 Cutting bow
20 a Rubber foot
20 b Rubber foot
25 Locking bolt for freestanding support
Translation of the original instruction