Table Des Matières; Introduction; Symbols On The Product - McCulloch B43BT Manuel D'utilisation

INTRODUCTION.......................................................... 11
SAFETY........................................................................12
ASSEMBLY.................................................................. 16
OPERATION.................................................................16
Operator's manual
The initial language of this operator's manual is English.
Operator's manuals in other languages are translations
from English.
Overview
(Fig. 1 )
1. Blade
2. Grease filler cap, bevel gear
3. Bevel gear
4. Cutting attachment guard
5. Shaft
6. Start throttle button
7. Stop switch
8. Throttle trigger
9. Throttle lockout
10. Suspension ring
11. Cylinder cover
12. Starter rope handle
13. Fuel tank
14. Choke control
15. Air filter cover
16. Nut
17. Support flange
18. Support cup
19. Protective guard
20. Handlebar clamp
21. Operator's manual
22. Transport guard
23. Socket Wrench
24. Hex wrench
25. Harness
26. Trimmer head
27. Air purge
28. Washer
29. Retainer pin
30. Hex wrench
31. Zip tie
462 - 002 - 07.02.2018
Contents
MAINTENANCE............................................................19
TRANSPORTATION AND STORAGE......................... 21
TECHNICAL DATA.......................................................21
ACCESSORIES............................................................22

INTRODUCTION

Symbols on the product

(Fig. 2 )
(Fig. 3 )
(Fig. 4 )
(Fig. 5 )
(Fig. 6 )
(Fig. 7 )
(Fig. 8 )
(Fig. 9 )
(Fig. 10 )
(Fig. 11 )
(Fig. 12 )
WARNING! This product is dangerous.
Injury or death can occur to the operator or
bystanders if the product is not used
carefully and correctly. To prevent injury to
the operator or bystanders, read and obey
all safety instructions in the operator's
manual.
Please read the operator's manual carefully
and make sure that you understand the
instructions before use.
Use a protective helmet in locations where
objects can fall on you. Use approved
hearing protection. Use approved eye
protection.
Use approved protective gloves.
Use heavy-duty slip-resistant boots.
The product can cause objects to eject,
which can cause injury.
Maximum speed of the output shaft.
Keep a minimum of 15 m (50 ft) distance to
persons and animals during operation of the
product.
Risk of blade thrust if the cutting equipment
touches an object that it does not
immediately cut. The product can cut off
body parts. Keep a minimum of 15 m (50 ft)
distance to persons and animals during
operation of the product.
Air purge bulb.
Choke: Set the choke control in the choke
position.
11