Important Safety Information; Fire Hazard - Hatco SERV-RITE SRB Série Manuel D'installation Et D'utilisation

Read the following important safety information before using this equipment to avoid serious injury or death and
to avoid damage to equipment or property.
WARNING
ELECTRIC SHOCK HAZARD:
• Plug unit into a properly grounded electrical outlet of
the correct voltage, size, and plug configuration. If the
plug and receptacle do not match, contact a qualified
electrician to determine and install the proper voltage
and size electrical outlet.
• Unplug the power cord or turn the power OFF at the
fused disconnect switch/circuit breaker and allow the
unit to cool before performing any maintenance or
cleaning.
• DO NOT submerge or saturate with water. Unit is not
waterproof. Do not operate if unit has been submerged
or saturated with water.
• Unit is not weatherproof. Locate the unit indoors where
the ambient air temperature is a minimum of 21°C
(70°F).
• Do not steam clean or use excessive water on the unit.
• This unit is not "jet-proof" construction. Do not use jet-
clean spray to clean this unit.
• Do not pull unit by power cord.
• Discontinue use if power cord is frayed or worn.
• Do not attempt to repair or replace a damaged power
cord. The cord must be replaced by Hatco, an Authorized
Hatco Service Agent, or a person with similar
qualifications.
• Do not clean the unit when it is energized or hot.
• Do not allow liquids to spill into the unit.
• Do not fill SRB and SRBW models with water. They are
dry heat units only, not steam table units.
• Use only Genuine Hatco Replacement Parts when
service is required. Failure to use Genuine Hatco
Replacement Parts will void all warranties and may
subject operators of the equipment to hazardous
electrical voltage, resulting in electrical shock or burn.
Genuine Hatco Replacement Parts are specified to
operate safely in the environments in which they are
used. Some aftermarket or generic replacement parts
do not have the characteristics that will allow them to
operate safely in Hatco equipment.
FIRE HAZARD: Locate
25 mm (1") from combustible walls and materials. If safe
distances are not maintained, combustion or discoloration
could occur.
the unit a minimum

IMPORTANT SAFETY INFORMATION

Use only low pressure halogen light/heat lamps that meet
or exceed National Sanitation Foundation (NSF) standards
and are specifically designed for food holding areas.
Make sure food product has been heated to the proper
food-safe temperature before placing on the unit. Failure
to heat food product properly may result in serious health
risks. This unit is for holding preheated food product only.
This unit must be serviced by qualified personnel only.
Service by unqualified personnel may lead to electric
shock or burn.
This unit has no "user-serviceable" parts. If service is
required on this unit, contact an Authorized Hatco Service
Agent or contact the Hatco Service Department at 414-671-
6350; fax 414-671-3976.
BURN HAZARD: Some exterior surfaces on the unit will get
hot. Use caution when touching these areas.
Locate the unit at the proper counter height in an area that
is convenient for use. The location should be level to prevent
the unit or its contents from falling accidentally and strong
enough to support the weight of the unit and contents.
Do not lay unit on the side with the control panel or damage
to the unit could occur.
Use non-abrasive cleaners only. Abrasive cleaners could
scratch the finish of the unit, marring its appearance and
making it susceptible to soil accumulation.
Do not slide pans across glass surface, use rough-
bottomed pans, or drop anything on glass surface.
Scratching or breakage may occur. Damage to glass
surface or breakage of glass caused by misuse is not
covered under warranty.
Do not place anything on top of the glass sneeze guard. It
is not designed to be a weight-bearing component.
Do not attempt to install the glass sneeze guard alone.
Installation of the glass sneeze guard is a two-person job.
of
WARNING
CAUTION
NOTICE