Programming The Remote Control - Becker Centronic MemoControl MC415 Notice De Montage Et D'utilisation

Programming the remote control

The central command 1-5 cannot be programmed separ-
ately.
1) Programming the master transmitter
a) Putting the receiver into programming mode
Follow the Assembly and Operating Instructions for the re-
ceiver.
•
Switch off the receiver power for 5 seconds, then switch it back on.
or
•
operate the programming button or the radio switch on the receiver.
The receiver is now in programming mode for 3 minutes.
b) Programming the master transmitter
Press the programming button on the master transmitter whilst in program-
ming mode until the receiver confirms that programming was successful.
The programming process is now complete.
2) Programming additional transmitters
1. Press the programming button of the master transmitter until the re-
ceiver confirms.
2. Then press the programming button of the new transmitter until the re-
ceiver confirms.
3. Now press the programming button of the new transmitter again.
4. The receiver confirms successful programming.
The maximum transmitter range on and in the building is up to 10 m and in the
open up to 100 m.
17 - en