Publicité
Les langues disponibles
Les langues disponibles
Atlantic's Auto Fill Kit is designed to maintain the correct level of water in your
fountain basin, water garden, pond-free waterfall or other type of water
storage unit.
Labeled drill points have been provided for the proper Auto Fill location on
all Atlantic products (see the products' installation manuals for drill point
specifications). If you are using any non-Atlantic product, the Auto Fill must be
positioned in an area free of obstructions so the float can travel up and down.
The center point of the Auto Fill should be located 1 ½" to 2" above the
normal operating water level.
Once you have determined the location of the Auto Fill, drill a
spade bit or hole saw. Insert the Auto Fill, making sure the gasket is on the
water side of the unit, and the plastic retaining nut is on the outside. Thread
the retaining nut onto the Auto Fill Valve, being careful not to over-tighten.
The Auto Fill Kit includes fittings for connection to a garden hose, ½" irrigation
line, and ½" Sch 40 PVC. Wrap the ½" male threads on the Auto Fill with thread
sealant and install the fitting of your choice. Once water is supplied to the Auto
Fill it will maintain the set water level by automatically adding water when the
level drops. This level can be adjusted by loosening the wing nut and raising
and lowering the height of the Auto Fill float.
Flow Rate: 0.5 to 1.5 gpm / Inlet Pressure: 80 psi max
AUTO-FILL
VALVE
WING NUT
WATER LEVEL
GASKET
RETAINING
NUT
7
/
" hole using a
8
OUTLET
FITTING
Publicité
