23_Troubleshooting; 24_Packaging; 25_Copyright; 26_Product Modifications - Elite Suito-T Mode D'emploi

EN
with EU laws (see "Declaration of conformity", page 119
may be voided if a charger different from the original is
used.
- Elite cannot be held responsible for any malfunction
involving third party software / app / device.
- The presence of high-voltage electric lines, traffic lights,
electric railway lines, bus or tram electric lines, television
sets, automobiles, cycle computers, gym equipment and
mobile phones inside the operating range of the console,
etc., can be the cause of interference. Therefore the use
of other wireless receivers may alter or completely inhibit
operation of the SUITO-T due to such interference.
- Do not expose the SUITO-T to direct sunlight for long
periods when they are not in use.

23_TROUBLESHOOTING

- Problem: The wheel appears to be skipping slightly while
training.
- Answer: The internal transmission belt might be slightly
loose. Please contact Elite for further info on how to proceed.
WARNING: Don't proceed with tensioning the belt on your
own as it might break. Should it break, you'll have to send the
hometrainer back to Elite or one of its service centers.
- Problem: the displayed speed appears to be very high (even
more than 100km/h).
- Answer: It's possible that the roller circumference has been
incorrectly set on the device you're using.
SUITO-T sends training data based on various protocols. One
of these is the protocol used by speed sensors. If the device
you're using employs said protocol you must change the
wheel circumference that had been set.
The wheel circumference value that must be set equals the
actual value of the wheel divided by 24,8. For instance: if
the circumference is 2095 mm, the value you must insert as
circumference equals 2095 / 24,8 = 84 mm.
- Problem: SUITO-T is not connecting to the device.
- Answer: try restarting the device / phone /tablet /computer.
Also restart the hometrainer before reconnecting.
- Problem: the bicycle isn't perfectly vertical.
- Answer: First make sure that the bicycle is properly locked
with the quick release. Alternatively make sure that the quick
release is fully inserted in the dropouts on both sides by fully
opening the frame.
Try adjusting the two external feet by unscrewing to raise the
related leg.

24_PACKAGING

If the roller needs to be shipped, careful packaging is critical:
46
- remove the charger cable from the SUITO-T;
- pack up the SUITO-T in its original box.
During shipments, packs often undergo mistreatment and
very hard impacts, therefore inadequate packing can result in
permanent damage to the roller. This type of damage is not
covered by the warranty.
Note: before sending the roller or any other component
assistance, always firstly consult Elite or the distributor.
Any items received without prior agreement will be rejected.

25_COPYRIGHT

No part of this manual may be reproduced or transmitted
without the written authorization of Elite S.r.l.
The Elite SUITO-T software and relative code are property
of Elite S.r.l.

26_PRODUCT MODIFICATIONS

Also in view of any technical update, ELITE reserves the right to
make changes to the products or their specifications without
being obliged to notify or inform the Customer beforehand for:
a) changes that do not affect negatively the product
performance;
b) changes required to meet or improve the product
specifications;
c) changes necessary for the products to comply with the
applicable legal requirements.
ELITE also reserves the right to supply these products with
these improvements without being obliged to or responsible
for applying the same modifications to any previously
purchased products, reserving also the right to change
prices and model availability according to market conditions,
component availability and other corporate considerations.

27_DISCLAIMER

Elite S.r.l. is not liable for any temporary or permanent
damage to the physical integrity of the user, whether direct or
indirect, resulting from the use of the trainer.

28_ INFORMATION ON PRODUCT DISPOSAL

1) WITHIN THE EUROPEAN UNION
This product conforms with European Directives
2002/95/CE, 2002/96/CE and 2003/108/CE.
The crossed bin symbol given on the equipment or
on the packaging indicates that at the end of its
service life the product must be collected separately
from other waste.
Therefore at the end of its useful life the user must take the
equipment to an appropriate centre for the differentiated
collection of electronic and electrotechnical waste, or return
it to the dealer when purchasing a new product of equivalent
type.