Invacare H112 Marina Manuel D'utilisation page 3

General
Important note:
This manual MUST be given to the user of the product.
BEFORE using this product, read this manual and save for
future reference.
This User Manual contains important information about
using the product. In order to ensure safety when using
the product, read the User Manual carefully and follow the
safety information.
If your vision is impaired, you can view the user manual as a
PDF file on the Internet and enlarge it on-screen as required.
If you cannot enlarge the text and graphics sufficiently,
please contact the Invacare distributor for your country. For
addresses, see back page of this manual. If necessary, we
will provide you with a high resolution PDF file of the user
manual.
Intended use
The product is intended to be used as a seating aid for
bathtubs for people with sufficient torso stability. Any other
use is prohibited.
Operating temperature: 10 – 40 °C
Scope of delivery (Fig. 1)
The following components are included in the scope of
delivery:
A Seat board
B Handle
C Feet with screws (4 x)
D Pins (4 x)
E User manual
Compliance
Quality is of the utmost importance for our company; all
processes are based on the ISO 13485 standard.
This product features the CE mark, in compliance with the
Medical Device Directive 93/42/EEC Class 1.
Invacare is continuously working towards ensuring that the
company's impact on the environment, locally and globally,
is reduced to a minimum. We only use REACH compliant
materials and components.
For further information please contact Invacare in your
country (for addresses, see back page of this manual).
Warranty
We provide a manufacturer's warranty for the product
in accordance with our General Terms and Conditions of
Business in the respective countries. Warranty claims can
only be made through the provider from whom the appliance
was obtained.
Service life
The expected service life of this product is three years when
used in accordance with safety instructions and intended
use, stated in this manual. The effective service life can vary
according to frequency and intensity of use.
1526005-E
IenI
Safety
Safety information
WARNING!
Risk of falling!
– Do not stand on this product.
– Do not use as a climbing or transfer aid.
WARNING!
Risk of injury!
– Do not use if defective.
– Do not make any unauthorized alterations or
modifications to the product.
Labels and symbols on the product (Fig. 2)
A This product complies with Directive 93/42/EEC
concerning medical devices. The launch date of this
product is stated in the CE declaration of conformity.
Date of manufacture
B
C Lot number
D Maximum user weight
Read user manual
E
Product designation
F
Manufacturer address
G
The identification label is attached to the underside
of the bath board.
Setup and usage
Assembling the product
The bath board is suitable for bath tubs with an inner width
from 400 – 620 mm (Fig. 3).
1. Attach the handle to the seat board in the correct
orientation (Fig. 4).
WARNING!
– Make sure that the handle fully engages in the
seat board.
The handle can not be removed again after assembly.
2. Remove the screws from the feet.
3. Attach the feet with the screws to the seat board (Fig. 5).
4. Secure the feet with the pins (Fig. 6).
Placing the bath board on the bath tub (Fig. 7)
1. Slightly loosen all four feet by turning them
counterclockwise.
2. Slide the feet inwards.
3. Place the bath board with the feet showing down on
the bath tub.
4. Slide all feet equally to the inner edge of the bath tub.
WARNING!
– Make sure that the bath board legs are mounted
tight to the bath tub inner wall.
5. Fasten all four feet by screwing them clockwise until
they stop.
3