Cleaning And Care - Korona 20205 Mode D'emploi

Instruction Manual
ENGLISH
You can stop the boiling process any time by pushing the On/
Off button (4).
Attention: The boiling process is not stopped by only removing
the unit from the power base. The unit must properly be
switched off (0-position). Otherwise, once put back onto the
base (7) the unit will resume the boiling process as the switch
is still set to On-position.
Water left over from a previous boiling cycle can be re-used
in the next boiling cycle. However, always make sure that the
water level is not too low.
Always unplug the appliance after use.
Dry-boil cut-out
Your kettle is equipped with a boil-dry cut-out, which will switch
off the kettle automatically, should it accidentally be operated
without water or by not observing the Minimum water level.
In the event of such a safety cut-out unplug the appliance
immediately and let it cool down for approx. 10 minutes.
Afterwards, your kettle is ready for use again.

Cleaning and Care

Before cleaning, always switch off the appliance and disconnect
it from the mains and let it completely cool down. Never
immerse the appliance in water. Danger! Electric Shock!
Clean the body of the appliance with a moistened soft cloth.
Do not use any aggressive cleaning agents and/or other hard
objects to clean the appliance.
Open the lid (2) and remove the filter. Clean it under running tap
water, if necessary, with a soft nylon brush. Dry it afterwards
and reinsert the filter into the spout.
DESCALING
Descale your appliance in regular intervals (approx. every 3 – 6
17