Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Installation Instructions
Threaded Rod Installation
The LPK1 may be suspended from four 3/8" diameter ASTM
A307 or stronger threaded rods (not included) which are
secured to a 1-5/8" x 1-5/8" 12ga metal framing strut channel
(spanning a maximum of 4 feet--not included) by ASTM A307 or
stronger 3/8" channel nuts (not included).
WARNING:
IMPROPER INSTALLATION CAN RESULT IN
SERIOUS PERSONAL INJURY OR DAMAGE TO
EQUIPMENT! Structural members MUST be capable of
supporting five times the combined weight of all equipment
being mounted.
1.
Carefully determine required mount position.
IMPORTANT ! : This will require knowing the lens to
screen distance. See projector specifications for
determining this distance.
2.
Secure one end of the threaded rod to the structural
member.
3.
Install four 3/8" jam nuts and washers on each threaded rod.
4.
Install the LPK1 with VCM (not included) onto the threaded
rod. (See Figure 7)
5.
Secure the LPK1 to the threaded rod using four 3/8"
washers and jam nuts. (See Figure 7)
4
x 8
5
Figure 7
x 8
INSTALLING PROJECTOR
Install projector with attached interface bracket to VCM (not
included) following instructions included with the VCM.
LPK1
7
Publicité
Table des Matières
