Replacing The Nanocloud Rotary Humidification Wick - Philips HU5930 Mode D'emploi

Note
•
Do not touch the pleated filter
surface, or smell the filter as it has
collected pollutants from the air.
•
Wash your hands after disposing of
the used filters.
2
Remove all packaging material of
the new NanoProtect filter (fig. e).
3
Place the new NanoProtect filter
into the appliance (fig. f).
4
Touch and hold the reset button
for 3 seconds to reset the
NanoProtect filter lifetime counter
(fig. ƒ).
Replacing the
NanoCloud rotary
humidification wick
Filter alert light
status
Filter replacement
light starts
flashing (fig. ‡)
1
Take the wick wheel off the wick
support (fig. ~).
2
Unfasten the locks on the edge of
the wheel (fig. ‰).
3
Grip the snap-fit components
on the other side of the plate to
release the wick from the wheel
(fig. Š).
4
Take the used NanoCloud rotary
humidification wick out (fig. ‹) .
5
Remove all packaging material
of the new NanoCloud rotary
humidification wick (fig. Œ).
Follow this
Replace the
NanoCloud rotary
humidification
wick
6
Place the new NanoCloud rotary
humidification wick in the wick
wheel, and then fasten the locks on
the wick wheel (fig. ).
7
Place the wick wheel on the wick
support (fig. k).
Note
•
When placing the wick wheel on the
wick support, make sure that the
projections on the wick wheel falls
into the corresponding grooves.
8
Place the water tray and water tank
back into the appliance.
9
Touch and hold the reset button
for 3 seconds to reset the
NanoCloud rotary humidification
wick lifetime counter (fig. ƒ).
EN 13