Important Safety Instructions; Electrical Requirements - Whirlpool GBW3050TS Guide D'utilisation Et D'entretien

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

IMPORTANT SAFETY INSTRUCTIONS

WARNING:
To reduce the risk of fire, electrical shock,
injury to persons, or damage when using the warming drawer,
follow basic precautions, including the following:
I
Read all instructions.
I
Proper Installation – Be sure the warming drawer is
properly installed and grounded by a qualified technician.
I
Never Use the Warming Drawer for Warming or Heating
the Room.
I
Do Not Leave Children Alone – Children should not be left
alone or unattended in area where warming drawer is in
use. They should never be allowed to sit or stand on any
part of the warming drawer.
I
Wear Proper Apparel – Loose-fitting or hanging garments
should never be worn while using the warming drawer.
I
User Servicing – Do not repair or replace any part of the
warming drawer unless specifically recommended in the
manual. All other servicing should be referred to a qualified
technician.
I
Storage in Warming Drawer – Flammable materials should
not be stored in a warming drawer.
I
Do Not Use Water on Grease Fires – Smother fire or flame
or use dry chemical or foam-type extinguisher.
I
Use Only Dry Potholders – Moist or damp potholders on
hot surfaces may result in burns from steam. Do not let
potholder touch hot heating elements. Do not use a towel
or other bulky cloth.
I
Use Care When Opening Drawer – Let hot air or steam
escape before removing or replacing food.
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
SAVE THESE INSTRUCTIONS

Electrical Requirements

I
Do Not Heat Unopened Food Containers – Build-up of
pressure may cause container to burst and result in injury.
I
Placement of Warming Drawer Racks – Always place
warming drawer racks in desired location while warming
drawer is cool. If rack must be moved while warming
drawer is hot, do not let potholder contact hot heating
element in warming drawer.
I
DO NOT TOUCH HEATING ELEMENTS OR INTERIOR
SURFACES OF WARMING DRAWER – Heating elements
may be hot even though they are dark in color. Interior
surfaces of a warming drawer become hot enough to
cause burns. During and after use, do not touch, or let
clothing or other flammable materials contact heating
elements or interior surfaces of warming drawer until they
have had sufficient time to cool. Other surfaces of the
warming drawer may become hot enough to cause burns –
among these surfaces are warming drawer vent openings
and surfaces near these openings and warming drawer
doors.
I
Do not touch hot surfaces. Use handles or knobs.
I
Do not operate any appliance with a damaged cord or plug
or after the appliance malfunctions or has been damaged
in any manner. Return appliance to the nearest authorized
service facility for examination, repair or adjustment.
I
The use of accessory attachments not recommended by
the warming drawer manufacturer may cause injuries.
I
Do not use warming drawer for other than intended use.
I
To reduce risk of electric shock, do not mount over a sink.
It is important to make sure you have the proper electrical
connection:
A 115 Volt, 60 Hz., AC only 15- or 20-amp electrical supply,
properly grounded in accordance with the National Electrical
Code and local codes and ordinances, is required.
It is recommended that a separate circuit, serving only your
warming drawer, be provided.
Recommended Grounding Method
The warming drawer must be grounded. This warming drawer is
equipped with a power supply cord having a 3 prong grounding
plug. To minimize possible shock hazard, the cord must be
plugged into a mating, 3 prong, grounding-type wall receptacle,
grounded in accordance with the National Electrical Code and
local codes and ordinances. If mating wall receptacle is not
available, it is the personal responsibility of the customer to have
a properly grounded, 3 prong wall receptacle installed by a
qualified electrician.
3

Publicité

Table des Matières
loading

Table des Matières