Technical Features - Vasco ELIA Manuel D'installation

INSTALLATION
The radiator may only be installed by a specialist partner.
Conditions of use
Observe the operating conditions for hot water heating systems
as defined in DIN 18380 "VOB German Contract Procedures for
Building Services".
Maintain water quality as defined in VDI 2035 "Prevention of
damage in hot water heating systems".
Observe the limitations for use in wet rooms as defined in
DIN 55900 "Coatings for radiators".
Use radiator only in closed heating systems.
Only store and transport radiator in the protective packaging.
Observe minimum clearances between radiator and surrounding
objects for air circulation.
When installing in rooms with bath or shower facilities:
Take protective areas as per DIN VDE 0100-701 into account.
Also follow all local regulations.
Note: The manufacturer prohibits installation of the products in
safety area 1 and 2.

Technical features

Operating pressure: max. 10 bar
Test pressure: 1.3 x operating pressure
Flow temperature: hot water up to 55 °C (131 °F)
Directions for installation
Protect radiator from damage
When installing, only remove protective packaging at the fixing
and connection points.
Only remove protective packaging completely during final
cleaning or prior to initial operation.
Fan connection
When installing the radiator (fixed installation), an all-pole dis-
connection device needs to be provided for the fan unit
according to DIN EN 60335-1.
Ensure that a correctly mounted unit connection box or wall
socket (230 V, 16 A fuse) is available within the cable range.
The wall emanating electrical connection must be freely
accessible and must not project out to the surface of the radiator
or the control unit. The radiator must not be attached directly
beneath a wall socket.
10
Warning
Risk of injury!
There are sharp edges inside the radiator.
Be careful when reaching in.
Prepare the mains cable for connection by folding away the
control unit (Fig. C).
Remove the adhesive tape and carefully pull the mains cable out
of the radiator, remove adhesive tape residue (Fig. D)
Fold the control unit back in until it clicks into place in the
radiator (Fig. E).
Connect the power supply cable.