Ordering Accessories; What Do I Do, If - AEG Electrolux CP 2 Série Mode D'emploi

822_949_318 CP2..._defnep.book Seite 44 Freitag, 2. November 2007 6:30 18
g

15.8 Ordering Accessories

To ensure years of satisfaction with
your coffee machine and prevent
faults arising, it is very important to
regularly clean and descale the coffee
machine. The original cleaning tablets
and descalant are obtainable direct
from us.
If you live in Germany, please call our
Order Hotline
Tel. 0 18 01-20 30 90.
16

What do I do, if ...

• ... coffee-making is interrupted and
the "Fill water tank" indicator (Fig. 3,
k) flashes?
– The water tank is empty. Fill the
water tank and press the
the key again.
– The water tank is not properly
inserted. Check that the water tank
is properly seated.
– The coffee is ground too finely.
Clean the coffee-making unit and
adjust the grinding texture.
– The coffee-making unit is blocked.
Refer to „Cleaning the Coffee-mak-
ing Unit" page 41. Completely
remove any encrusted coffee
remains from the coffee-making
unit, set a smaller coffee quantity.
• ... the "Fill water tank" indicator (Fig.
3, k) flashes, even though it is
sufficiently filled with water?
– Vent the coffee machine: Place a
container under the hot water noz-
zle. Then turn the Selection dial for
steam and hot water (Fig. 1, D) for a
few seconds to position
soon as water is ejected, turn the
selection dial back to position
• ... the coffee machine does not oper-
ate, and the "Empty grounds con-
tainer" indicator (Fig. 3, j)
flashes?
– Container is full: Empty container
and clean thoroughly; see „Emptying
the Coffee Grounds Container"
page 40.
44
• ... the coffee machine does not oper-
ate, and all 5 indicator lights Coffee
Quantity
ing?
– The coffee-making unit is overfilled.
Refer to „Cleaning the Coffee-mak-
ing Unit" page 41. Completely
remove any encrusted coffee
remains from the coffee-making
unit.
– Reduce the amount of ground cof-
fee spooned in.
– Set a small coffee quantity; see
„Changing and Saving the Coffee
Quantity" page 38.
– Check ejector.
– If you are unable to remedy the
fault, please contact the AEG Ser-
key or
viceline.
• ... "Clean" key (Fig. 3, f)
flashing?
– Number of coffees dispensed
necessitates cleaning: Run cleaning
program; see „Running the Cleaning
Program" page 42.
• ... the cleaning program cannot be
started?
– Turn the bean container to the pow-
der setting, then start the cleaning
program.
• ... "Descale" key (Fig. 3, e)
flashing?
– Number of coffees dispensed
necessitates descaling: Carry out
descaling: see „Running the
Descaling Program" page 42.
• ... the espresso/coffee is not hot
enough?
– Preheat the cups with hot water.
. As
– Increase coffee temperature; see
„Setting the Coffee Temperature"
.
page 38.
• ... the espresso/coffee is too weak?
– Not enough ground coffee. Increase
the amount of ground coffee, max. 2
measuring spoons.
– The coffee bean container is empty.
Add coffee beans.
– The coffee quantity is set too low.
and or are flash-
is
is