Cooper Lighting Solutions WPSQLED Instructions D'installation page 2

Installation Instructions - WPSQLED
INSTALLATION
This lighting fixture is intended for wall mount only. Inverted
mounting can result in overheating and possible water
entry. Please refer to instructions below for installation.
Mounting height should be a minimum of 6 feet.
N ote:
Tools Required
Philips screwdriver, Torx T-20 bit (included)
1. Open the fixture by loosening the two tamper resistant
screws with the Torx T-20 bit (included) on the side and
remove the glass door assembly. (Figure 1)
2. Prepare the back plate for mounting by drilling or
knocking out the appropriate holes. (Figure 2)
3. Line up the back plate in the desired location and
mount securely. Caulk all holes in the back plate,
mounting and conduit holes. Caulk around back plate
where the luminaire contacts the mounting surface to
provide a watertight seal.
4. If using electrical conduit, remove the screw cap from
the desired conduit hole and replace with conduit.
Route the branch circuit wires inside the fixture. If
using a junction box, bring the branch circuit wires
through the rear hole into the fixture.
5. Splice the branch circuit power leads to the fixture
power leads, black to black (hot), white to white
(neutral), and green to green (ground). (Figure 3)
6. Close and tighten the assembly using the provided
tamper-proof screws.
Mounting
The back plate has a cast-in drill and knock-out template
to match any standard recessed junction box, three 5/8"
knock-outs for mounting holes and three 1/2" NPS tapped
holes for surface conduit or photo control unit. (Figure 2)
A – 5/8" diameter knockouts
B – Wireway
C – 1/2" NPS tapped holes
N ote: To weatherproof your outdoor installation, all gaskets
must be seated properly and all screws inserted and
tightened firmly. Apply weatherproof silicone sealant
around all edges between the fixture housing and
mounting surface.
2
COOPER LIGHTING SOLUTIONS
IB514026EN Installation instructions
Figure 1
A
C
B
Figure 2
Line (Black)
White (Common)
Green (Ground)
Figure 3
A
A
C
Black
White
Green (Ground)