Gewiss GW A9 471 Manuel D'utilisation page 17

GENERAL DESCRIPTION
Change mode output
1. wait for 10 seconds without touching any channel
2. wait until you hear a long beep
3. wait until all six LEDs are briefly flashing magenta.
4. wait until the flashing stops and the current status signalling or night-time localisation is re-
stored.
During this configuration phase, the messages from the BUS are ignored (they will be managed
after you have quit the configuration phase).
ACOUSTIC SIGNAL
The acoustic signal is associated with touch (short or long). The signal can be enabled/disabled as
follows:
Change mode input
1. touch the plate as shown in figure B for at least 15 seconds, without touching the device chan-
nels
2. wait until you hear two long beeps, then release
3. wait until all six LEDs are flashing magenta
4. activation of LED 1 red, LED 2 white, LED 3 and LED 5 according to the configuration active at
that moment
Parameter personalisation
Cyclically activate/deactivate the reproduction of the sound effects associated with short and long
touches by making consecutive touches on channel CH3 as indicated in the table:
Change mode output
1. wait for 10 seconds without touching any channel
2. wait until you hear a long beep
3. wait until all six LEDs are briefly flashing magenta.
4. wait until the flashing stops and the current status signalling or night-time localisation is re-
stored.
During this configuration phase, the messages from the BUS are ignored (they will be managed
after you have quit the configuration phase).
LED 3
Fixed green
Flashing green
ACOUSTIC SIGNAL
Active
Deactivated
17