Operating Elements; Before Commissioning; Installing The Brushes - Tornado 99406 Mode D'emploi

25
24
1 Lock for fresh water reservoir
2 Switch for brush drive
3 Switch for detergent solution
4 Hose for detergent solution
5 Lint sieve (suction)
6 Lock of pushing handle
7 Release button for the transport
wheel
8 Bearing wheel
9 Push handle
10 Strain relief clamp
11 Support of the transport wheel
12 Clip
13 Fresh water tank
14 Dirt water reservoir
15 Push-button for vacuum bar
change
16 Float
17 Button for brush change
18 Chassis
19 Vacuum bar
20 Brushing rollers
21 Rotating handle for brush contact
pressure
22 Pedal to lower vacuum bar
23 Mains plug
24 Carrying handle for wastewater res-
ervoir
25 Fresh water tank cover
6

Operating elements

Before Commissioning

Installing the pushing handle
Slide the upper slider half onto the

lower slider half.
Warning
Risk of damage. Do not pinch the cable
during the installation.
Align the borings (2 possible height

adjustments).
Connect the slider halves to the

lock screws, discs and star grips.
Fasten the cable to the slider using

clips.
3
-
EN
Installing the transport wheels
Insert the transport wheel axles into

the borings on the appliance and
lock them.

Installing the Brushes

The brushes must be installed before
the initial operation (see "Maintenance
works").