Manufacturer's Warranty; Spare Parts Lists - REMS E-Push 2 Notice D'utilisation

eng
5. Faults
WARNING
To clear faults, switch off the electric pressure test pump at the On/Off switch (1) and pull out the mains plug!
5.1. Fault: Pressure test pump running but builds up no pressure.
Cause:
● "Pressure" regulating valve (8) is open.
● Pressure test pump sucks in air.
● Suction filter (4) and/or suction filter with check valve (10) on the suction
hose are blocked.
● Electric pressure test pump defective.
5.2. Fault: Pressure on the pressure gauge (9) fluctuates irregularly.
Cause:
● Air in the pipe system.
5.3. Fault: Motor does not start, hums.
Cause:
● Electric pressure test pump blocked.
● Unsuitable voltage supply.
● Unsuitable extension lead.
● Pressure is applied in the pump with closed "Test" shutoff valve (7).
5.4. Fault: Motor stops suddenly during operation.
Cause:
● Motor circuit breaker has tripped.
● Pump run hot or blocked.
6. Disposal
The electric pressure test pump may not be thrown in the domestic waste after
use. It must be disposed of properly by law.

7. Manufacturer's Warranty

The warranty period shall be 12 months from delivery of the new product to the
first user. The date of delivery shall be documented by the submission of the
original purchase documents, which must include the date of purchase and the
designation of the product. All functional defects occurring within the warranty
period, which are clearly the consequence of defects in production or materials,
will be remedied free of charge. The remedy of defects shall not extend or
renew the warranty period for the product. Damage attributable to natural wear
and tear, incorrect treatment or misuse, failure to observe the operational
instructions, unsuitable operating materials, excessive demand, use for unau-
thorized purposes, interventions by the customer or a third party or other
reasons, for which REMS is not responsible, shall be excluded from the warranty
Services under the warranty may only be provided by customer service stations
authorized for this purpose by REMS. Complaints will only be accepted if the
product is returned to a customer service station authorized by REMS without
prior interference in an unassembled condition. Replaced products and parts
shall become the property of REMS.
The user shall be responsible for the cost of shipping and returning the product.
The legal rights of the user, in particular the right to make claims against the
seller under the warranty terms, shall not be affected. This manufacturer's
warranty only applies for new products which are purchased in the European
Union, in Norway or in Switzerland.
This warranty is subject to German law with the exclusion of the United Nations
Convention on Contracts for the International Sales of Goods (CISG).

8. Spare parts lists

For spare parts lists, see www.rems.de → Downloads → Parts lists.
Remedy:
● Set the desired pressure by turning the "Pressure" regulating valve (8) to the
right.
● Check whether the suction filter with check valve (10) is immersed completely
in the water. Seal screw connections.
● Clean or replace suction filter (4) and/or suction filter with check valve (10).
● Have the electric pressure test pump inspected by an authorised REMS
Customer Service Workshop.
Remedy:
● Vent the pipe system.
Remedy:
● "Pressure" regulating valve (8) is set to high or max. pressure, open by turning
to left or have the electric pressure test pump inspected by an authorised
REMS Customer Service Workshop.
● Have the voltage supply tested.
● Use approved extension lead.
● Open "Test" shutoff valve (7).
Remedy:
● Switch off electric pressure test pump at the On/Off switch (1) and allow to cool
down for approx. 30 minutes.
● Switch off electric pressure test pump at the On/Off switch (1) and allow to cool
down for approx. 30 minutes or have the electric pressure test pump inspected
by an authorised REMS Customer Service Workshop.
eng