Domo DO9220IB Mode D'emploi page 25

POSSIBLE PROBLEMS AND THEIR SOLUTIONS
PROBLEM
The compressor makes a lot of noise.
Indicator lamp 'water reservoir empty'
(ADD WATER) lights up.
There are no indicator lights on.
The ice is too big and there are bits of
broken ice sticking to it.
The appliance goes through the cycle, but
no ice comes out.
All indicator lights flash simultaneously.
The appliance works, but the water gets
warm.
The ice basket is full, but the indicator light
is not lit.
The appliance and the air around the
appliance become warm.
The operation of the appliance has been
interrupted, for example, by a power
outage or lack of water.
www.domo-elektro.be
POSSIBLE SOLUTION
· Check that the voltage indicated on the appliance
corresponds to the voltage of the electricity grid in
your home.
· Is the water reservoir empty? Fill the water reservoir
with water.
· There's air in the pump. Restart the appliance with
the on/off button.
· There is no power applied to the appliance. Check
the plug is placed in the socket.
· Make sure the fuse is not broken.
· It is possible that ice from a previous cycle has ended
up in the water reservoir. Turn off the appliance and
remove the ice from the water reservoir.
· The compressor or the ventilation motor is broken.
Contact the after-sales service.
· There is insufficient coolant in the appliance. Contact
the after-sales service.
· The water reservoir is blocked by ice cubes. Pull the
plug out of the socket, remove the ice from the water
reservoir. Plug the power cord back in and press
the on/off button. The appliance will restart after 3
minutes.
· Contact the after-sales service.
· The sensor is broken. Contact the after-sales service.
· This is normal. The temperature of the compressor
can be up to 90°C.
· It takes 3 minutes for the appliance to restart.
25
DO9220IB