Weller WSL 2 Manuel D'utilisation page 30

Be careful of what you do. Work with caution. Don't use the soldering tool if you are
not concentrated on your work.
20. Inspect the soldering tool for any damage.
Before further use of the soldering tool, safety devices or slightly damaged parts
must be carefully checked for error-free and intended operation. Inspect moving
parts for error-free operation and that they don't bind, or whether any parts are
damaged. All parts must be properly mounted and all requirements fulfilled for
guaranteed error-free operation of the soldering tool. Damaged safety devices and
parts must be repaired or replaced by a qualified technician, so long as nothing else
is indicated in the Operation Manual.
21. Attention.
Use only accessories or attachments which are listed in the accessories list of the
Operation Manual. Use only WELLER accessories or attachments on original
WELLER equipment. Use of other tools and other accessories can lead to a danger of
injury.
22. Repairs to your soldering tool should be carried out by qualified technician.
This soldering tool is in accordance with the relevant safety regulations. Repairs
should only be carried out by a qualified electrician using original WELLER
replacement parts. Failure to do so can lead to accidents for the operator.
23. Do not work on electrically live parts.
The grip of antistatic designed soldering tools is conductive.
24. Applications with other WELLER equipment.
If the soldering tool is to be used together with other WELLER equipment and attach-
ments, also observe the warning notices given in the corresponding Operation Manual.
25. Observe the valid safety regulations for your work place.
28
PK Elektronik Vertriebs GmbH, E-Mail: info@pkelektronik.com, Internet: www.pkelektronik.com