Switching On The Appliance; Dry Ironing; Steam Ironing - ARIETE Free Style 6236 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 15
Warning!
To avoid damaging the pump, never operate the appliance without any water in the tank, even for dry ironing. Do not
add any additives or chemicals (such as for example, amides, starches, perfume or other); Otherwise, the warranty
may be revoked.
The possible presence of water, condensate or moisture in the tank indicates only that the appliance has been
tested.
If it proves necessary to add water while ironing, always turn off the iron and unplug the power cord before filling the tank
with water.

Switching on the appliance

Before you turn on the appliance, make sure there is sufficient water inside the tank.
It is possible that at the first use of iron there are spills of white powder from the plate; this is normal and the effect
will disappear after delivering some steam blows.
At the first use of the iron you may notice a delay in the formation of steam: this is normal and is due to water
entering into circulation in the iron. You may need to press the steam and spray button several times for their
proper operation.
Place the appliance on a horizontal and stable surface. Put the iron on its iron rest (O) (Fig. 7).
Plug into the mains socket. The temperature control lamp (H) turns on.

DRY IRONING

For 'dry' ironing, without steam, after connecting the apparatus to the power supply just switch on the appliance and adjust
the thermostat knob (J) to the required temperature. Wait for the light (H) to turn off. Do not press the steam button.

STEAM IRONING

Steam ironing is only possible at high temperature. Ensure that there is enough water in the water tank.
The appliance is equipped with a regulator (C) which allows the steam output to be adjusted from a minimum to a maximum
according to ironing requirements. Position the temperature adjustment knob (J) on position (
temperature control lamp (H) turns off, move the steam adjustment selector (C) to the desired position. You get maximum
steam dispensing by moving the selector to the " " position. Moving it to "0" steam is not delivered.
Follow the instructions on the care label of the garment to be ironed. Make the dots shown on the iron correspond to those
shown on the label.
Warning!
Never dispense steam when the iron is placed on the iron rest (O).
If the iron is left inactive for a long time, before ironing it is recommended to hold it level and deliver a few shots of steam
into the ground to stabilize the jet and eliminate any condensation.
Shot of steam
If there is water in the tank and the temperature is set on (
button (D).
Spray button
Make sure the steam adjustment selector is set on "0" and that there is water in the tank. Press the spray button (E). It may
be necessary to press the spray button repeatedly to activate this function.
Filling the boiler during use
Warning!
Always check the level of water in the tank while you are ironing.
Warning!
Always turn off the appliance and remove the power cable plug from the socket-outlet before filling the tank with
water. Fill the tank up to the level marked MAX.
unplug it from the electric outlet. Lift the iron in cordless mode. Open the door filling (B). Fill the tank with cool tap water
(Fig. 5). Close the cover (B) again.
12
•••
) or on a higher level, all you have to do is press the steam
•••
) or higher. When the

Publicité

Table des Matières
loading

Table des Matières