Hendi 3500 Mode D'emploi page 5

Preparations before using for the first time
• Check to make sure the appliance is undamaged.
In case of any damage,
immediately and do NOT use the appliance.
• Remove all the packing material and protection
film (if applicable).
• Clean the appliance with luke-warm water and
a soft cloth.
• Place the appliance on a level, stable and hori-
zontal surface.
The control panel
1. "ON/OFF" key: Use this key to switch the appli-
ance on or to interrupt or reset the timer.
Operation
• Put the plug in the socket.
• Set the pan of your choice on the cooking sur-
face, bearing the above-mentioned instructions
in mind.
NOTE! Do not leave your pan on the burner while
empty as this may lead to damage to your pans.
• Switch the appliance on :
contact your supplier
• Make sure that there is at least 15cm clearance
around the appliance for ventilation.
• Position the appliance in such a way that the plug
is accessible at all times.
• Important: This appliance can only be used with
our specially designed wok (Hendi item's no.
239773) (Not included).
2. "Arrow" keys: Use these keys for programming
the capacity. The up arrow increases the setting
value and the down arrow reduces the setting
value.
• NOTE! This appliance can only be used in combi-
nation with wok pan 239773.
• Now you can programme the capacity required by
means of the arrow keys, 3500W being the high-
est and 500W the lowest position.
• Once you have reached the required result, you
can switch off the appliance by pressing the "ON/
OFF" key. The display will go off
• If you do not use the appliance for an extended
period, remove the plug from the electrical sock-
et and remove the pan from the appliance.
NOTE! Allow the appliance to cool off before you
touch it. The ceramic plate is very hot after use.
EN
5