Whirlpool W10891955A Guide D'utilisation Et D'entretien page 24

Troubleshooting
First try the solutions suggested here or visit our website at www.whirlpool.com/product_help –
If you experience
Error Code Appears in Display (for 2 and 3 digit displays) (cont.)
All detergent level status
lights are lit
(on some models)
All detergent level status
lights are lit (on some
models) (cont.)
F# E# or F## E##
code
other than as described
above appears in display
Washer making error
beeps
Washer beeps when
START is touched
Clean Washer LED flashing
at end of wash cycle
(on some models)
24
In Canada www.whirlpool.ca for assistance and to possibly avoid a service call.
Possible Causes
Detergent dispenser is not securely
in place.
Detergent Level sensor error.
System error code.
Door has not been opened and
closed for at least 3 cycles.
Door not closed.
The washer has run 30 wash cycles
and is indicating a reminder to run the
Clean Washer with affresh
Pull out the dispenser, fill with detergent, and slide it back
in place.
Touch POWER to reset system. If all detergent status LEDs
remain lit, unplug washer for 30 seconds; then plug back in.
If problem remains, remove cartridge and use single-load
dispensing until problem can be resolved.
Touch POWER once to clear the code. Then touch POWER
again to restart washer. If code appears again, call for service.
Unplug washer for 30 seconds; then plug back in.
This code may occur when the washer is first turned on.
Open and close the door to clear the display.
Close the door completely.
Run the Clean Washer with affresh
with affresh
®
at the end of a wash cycle after running 3 more regular wash
cycle.
®
cycles. After 30 more wash cycles are completed, the Clean
Washer with affresh
cycle as a reminder.
Solution
cycle. If the Clean Washer
®
cycle is not turned on, the LED will stop flashing
LED will again flash at the end of a wash
®