Hagen Fluval NANO Mode D'emploi page 6

4. Slide the foam cartridge out of
filter case, remove the Fine Foam
Pad from cartridge and place in an
empty bucket. (G)
5. Rinse Bio-Foam or Fine Foam Pad
using water taken from
the aquarium or replace
following the recommended
replacement schedule.
hOW TO CARE FOR ThE
IMPELLER AND MOTOR
The impeller and impeller well (where
the impeller is located) should be
cleaned at least once a month, more
often if necessary. The impeller well
has an effective self-cleaning feature.
However, it is recommended that
you remove the motor and inspect
the impeller as part of your routine
maintenance. Keeping the impeller
clean lengthens its life and the life of
the motor.
Cleaning the Impeller:
1. Unplug the filter and remove it
from the installation.
2. Separate the filter case from the
motor housing. (E)
3. Remove impeller cover. (h)
4. Grasp the blades of the impeller
fan to pull out the impeller. (I)
5. Thoroughly clean the impeller and
the impeller well to remove slime,
dirt or debris. NEvER use soap or
detergents as these products
could be harmful to the
inhabitants of your aquarium.
6. Place the impeller back into the
impeller well. Replace the impeller
cover, and then re-attach the filter
case to the motor housing.
(I)
(E)
(F)
(G)
(H)