Parts Diagram; Motor Housing - Hagen Fluval NANO Mode D'emploi

(For North America only)
This appliance has a polarized plug (one blade is wider than the
13.
other). As a safety feature, this plug will fit in a polarized outlet only
one way. If the plug does not fit fully in the outlet, reverse the plug.
If it still does not fit, contact a qualified electrician. Never use with an
extension cord unless plug can be fully inserted. Do not attempt to
defeat this safety feature.
SAvE ThESE INSTRUCTIONS

PARTS DIAGRAM

1. Spray Bar
2. Flow Control
Elbow

3. Motor housing

INSTALLATION and USE
WARNING: Disconnect the plug of all
aquarium appliances before placing your
hands into the aquarium water and / or
performing any maintenance of any kind.
Do not plug filter in until setup is complete
and aquarium is filled with water.
1. Unpack and identify all parts. Use the
parts diagram as a guide.
2. Rinse the filter case, Bio-Foam and
Fine Foam Pad in tap water.
3. Attach spray bar onto flow control
elbow. (A) Note: Adjust the water
flow rate by rotating the flow control
knob. (B) The spray bar is multi-
directional so water output can be
directed as needed.
4. Install the assembled piece onto
the filter. (C)
5. Place filter on the right rear area of
the aquarium.
4. Magnetic
Impeller
5. Impeller Cover
6. Bio-Foam
7. Foam Cartridge
8. Fine Foam Pad
9. Filter Case
(A)
(B)