Installation Instructions - Hansgrohe AXOR Montreux 16523 Série Mode D'emploi / Instructions De Montage


Safety Notes
Gloves should be worn during installation to prevent

crushing and cutting injuries.
The shower system may only be used for bathing,

hygienic and body cleansing purposes.
The hot and cold supplies must be of equal pressu-

res.

Installation Instructions

• The fitting must be installed, flushed and tested after
the valid norms.
• If the instantaneous water heater causes problems or
if you wish to increase the water flow, the EcoSmart®
(flow limiter) located behind the aerator can be
removed.
Technical Data
This mixer series-produced with EcoSmart®
(flow limiter)
Operating pressure:
Recommended operating pressure:
Test pressure:
(1 MPa = 10 bar = 147 PSI)
Hot water temperature:
Recommended hot water temp.:
The aerator is not equal to DIN EN 246
Hansgrohe mixers can be used together with
hydraulically and thermically controlled continuous flow
heaters if the flow pressure is at least 0,15 MPa.

English
Symbol description
max. 1 MPa
0,1 – 0,5 MPa
1,6 MPa
max. 80°C
65°C
Assembly see page 31-33
Do not use silicone containing acetic acid!
Dimensions (see page 34 + 35)
Flow diagram (see page 34 + 35)

with EcoSmart®

without EcoSmart®
Spare parts (see page 36)
XXX = Colors
000 chrome plated
820 brushed nickel
830 polished nickel
Special accessories
special tool (58085000) order as an extra
Installation kit order as an extra
Operation (see page 38)
Cleaning
Cleaning recommendations, see enclosed
brochure.
Test certificate (see page 37)