Kreg Crown-Pro Guide D'utilisation page 4

Step-by-Step
38°
Find the spring angle of your molding using
1
the included Angle Finder.
A. There are three common spring angles
(38°, 45°, and 52°). The spring angle is
simply the angle at which the bottom of the
molding intersects the wall. The 'bottom' of
the piece is always the more 'detailed' edge.
B. To fi nd the spring angle of your molding, place
one side of the Angle fi nder on the large fl at
back of the workpiece, and the other side on
the bottom angle of the workpiece, as shown.
800-447-8638
Bottom of Molding
(against the wall)
Set your Crown-Pro™ to match the spring
2
angle using the adjustment nut on the back.
A. Loosen the plastic nut on the bottom of the
Crown-Pro™ slightly so the angle can be set
on the Spring Scale. Set the scale to match
your spring angle and re-tighten the nut.
B. Although there are only 3 common spring
angles found on most home center moldings,
your Crown-Pro™ can be set to match any
spring angle between 30° and 65°.
Step-by-Step
38°
www.kregtool.com